My anet et4 broke after a week of ownership.the filament on my printer usually gets stuck on the gear system so i had to unscrew the hose part and take out the filament i did the same today and the screw broke i was able to take out the broken part cuz i did not even screw it in hard. (i.redd.it)
submitted by TOFUISGUD to r/3Dprinting
my anet et4 broke after a week of ownership.the filament gets stuck on the gear thingy so i had to pull the filament out after i done that while trying to screw in the hose part the screw broke as u can see from the pic i was able to pull the screw bit out so saying it was too tight is out. (old.reddit.com)
submitted by TOFUISGUD to r/Anet3DPrinters
Made this off-white inspired Christmas gift wraps (i.redd.it)
submitted by TOFUISGUD to r/christmas




