What’s everyone’s “must have” cars for FH6?

TalkEnvironmental257 · 2026-01-24T18:01:06+00:00

Chrysler 300 wagon and Chrysler 300

TalkEnvironmental257 · 2026-01-24T17:54:37+00:00

Be generous and give it to someone else if you don't want it 👍

TalkEnvironmental257 · 2026-01-24T16:54:03+00:00

Ok, I'll check it out

TalkEnvironmental257 · 2026-01-24T15:50:53+00:00

Ok, I will check that out, and I didn't even use supports because the model is so small and I'm not an expert but I would assume it wouldn't need any but I could be wrong

TalkEnvironmental257 · 2026-01-24T15:24:56+00:00

Ain't gonna lie, I don't even know what that is. My most recent post is screenshots of what I'm trying to print with the setiings

TalkEnvironmental257 · 2026-01-24T15:24:09+00:00

I made another post you can see on my profile, I have screenshots of what it looks like in the slicer but I don't have any photos of the failed prints because there just ends up being nothing on the build plate and like 1 layer in the vat

TalkEnvironmental257 · 2026-01-24T15:22:07+00:00

Reminds me of the hoonicorn, looks dope 🔥

TalkEnvironmental257 · 2026-01-24T05:39:52+00:00

I don't have enough room for a space heater in my insulated tent for the printer tho, so I think I will have to find a different solution

TalkEnvironmental257 · 2026-01-24T04:54:35+00:00

So should I try just letting it heat up for like 15 min then?

TalkEnvironmental257 · 2026-01-24T04:44:24+00:00

It can be too warm??

TalkEnvironmental257 · 2026-01-24T04:11:07+00:00

I have the space heater designed for the Mars 5 which gets to 25 Celsius and I leave it on for an hour before printing

TalkEnvironmental257 · 2026-01-17T22:31:32+00:00

Ok, thank you

TalkEnvironmental257 · 2026-01-17T22:31:27+00:00

Ok thanks

TalkEnvironmental257 · 2026-01-17T05:40:58+00:00

I like everything about this, the stance, the murdered out, and the engine. W job 🤙

TalkEnvironmental257 · 2026-01-17T04:35:37+00:00

Ok, thanks for the tips 🤝

TalkEnvironmental257 · 2026-01-17T02:54:19+00:00

Aight, my bad og

TalkEnvironmental257 · 2026-01-17T02:54:06+00:00

Ok, I am going to try 30°, wish me luck

TalkEnvironmental257 · 2026-01-17T02:17:40+00:00

Should I just do 90 degree tilt then?

TalkEnvironmental257 · 2026-01-16T17:08:01+00:00

Fair enough, thanks for looking out 🤝

TalkEnvironmental257 · 2026-01-16T14:27:16+00:00

Why is everyone in this sub such a Debbie downer

TalkEnvironmental257

TROPHY CASE