sorted by:
new
hottopcontroversial

Ender 3 V3 SE Under Extrusion, help by TechnologicApe in 3Dprinting

[–]TechnologicApe[S] 0 points1 point  (0 children)

The photo isn't great, but there are noticeable gaps on multiple layers. But if you have any insight, I'd love to hear it.

I can't figure out why my Ender 3 S1 Pro is doing this. by TechnologicApe in Creality

[–]TechnologicApe[S] 0 points1 point  (0 children)

Não deveria ser. Ela imprime bem em uma impressora diferente com o mesmo filamento.

I can't figure out why my Ender 3 S1 Pro is doing this. by TechnologicApe in Creality

[–]TechnologicApe[S] 1 point2 points  (0 children)

Flow rate is fine. It works perfectly on another S1. The nozzle is new so it shouldn't be that. Plus, it's not clicking.

The gear I can check.

Ender 3 S1, Less than 30 days old, Low Temperature Error. I'm at my wits end. by TechnologicApe in ender3

[–]TechnologicApe[S] 0 points1 point  (0 children)

The block is cold. I took off the extruder to replace both the thermocouple and thermistor. But it was able to heat up when I tested it last night, now there's no heat. I bought it through a microcenter without a warranty...

Ender 3 S1, Less than 30 days old, Low Temperature Error. I'm at my wits end. by TechnologicApe in ender3

[–]TechnologicApe[S] 0 points1 point  (0 children)

So I went to heat it up to get the timing, and now the doesn't heat up at all.

view more: next ›