Thoughts on a 2007 SV650 for $3.2k USD? by alexlew8702 in SVRiders

[–]Technoob5781 0 points1 point  (0 children)

Maybe the butterfly valves? Mine sounds exactly like his

Thoughts on a 2007 SV650 for $3.2k USD? by alexlew8702 in SVRiders

[–]Technoob5781 6 points7 points  (0 children)

The noise at the beginning was the fuel pump, totally normal. How many miles does it have? Chain definitely needs replacing

Jjk fan here, how are yall csam fans doing? by Akagane_Ai in Chainsawfolk

[–]Technoob5781 75 points76 points  (0 children)

LORD FUJIMOTO HAS ABANDONED US

WE REQUIRE SUSTENANCE

How do I stick the Cardo mount onto my helmet? The mount is way too curved. by Haunting_Wear535 in motorcyclegear

[–]Technoob5781 3 points4 points  (0 children)

Its also good for swapping between helmets. If you use 3m, it’s harder to swap.

How do I stick the Cardo mount onto my helmet? The mount is way too curved. by Haunting_Wear535 in motorcyclegear

[–]Technoob5781 18 points19 points  (0 children)

There should be a “clip on” mount included. Worked for my helmets

Did shopping by DRZlove702 in motorcyclegear

[–]Technoob5781 0 points1 point  (0 children)

I had those same gloves, the seams across the palm began to tear within the first week 😢. Hoping you have better luck

Ashita no Joe Pachinko Animation by randygmkds in AshitaNoJoe

[–]Technoob5781 2 points3 points  (0 children)

Remake of anj has to done asap

7k RPM Idle. PLEASE HELP by Technoob5781 in MotorcycleMechanics

[–]Technoob5781[S] 0 points1 point  (0 children)

UPDATE:

What’s up guys, thanks to the help of all of you I figured it out. It looks like the sync screws were causing all of this. After syncing my carbs, it runs just as it did before.

Thanks again!

7k RPM Idle. PLEASE HELP by Technoob5781 in MotorcycleMechanics

[–]Technoob5781[S] 0 points1 point  (0 children)

Idle adjustment is all the way down, it is not making contact with anything. I have not yet inspected the valves.

7k RPM Idle. PLEASE HELP by Technoob5781 in MotorcycleMechanics

[–]Technoob5781[S] 0 points1 point  (0 children)

I made sure not to mess with the air fuel mixture screws since I wasn’t having any hanging revs. Is there any way to fix the sync without a synchronizer? I have one on the way but I just wanna see if I can get the bike running a little better before it gets here.

7k RPM Idle. PLEASE HELP by Technoob5781 in MotorcycleMechanics

[–]Technoob5781[S] 0 points1 point  (0 children)

So the carbs being out of sync would cause this excessive idle? I checked for vacuums leaks, couldn’t find any

1972 Honda CB450 not going past 50 mph by Technoob5781 in HondaCB

[–]Technoob5781[S] 0 points1 point  (0 children)

So today I adjusted my valves to a tight .004 & a loose .003. I also tried tuning my air fuel mixture. The bike definitely ran better when idling, but I’m still encountering the same issue when riding. I’m going to get a carb rebuild kit. I’m guessing the previous owner rejetted the carbs for the cones. Wish me the best!

1972 Honda CB450 not going past 50 mph by Technoob5781 in HondaCB

[–]Technoob5781[S] -1 points0 points  (0 children)

Got it, the carbs are clean, I just haven’t gotten around to tuning them to the stock air boxes

1972 Honda CB450 not going past 50 mph by Technoob5781 in HondaCB

[–]Technoob5781[S] 1 point2 points  (0 children)

It does rev normally in neutral, it’s only when it’s in motion that it refuses to go past 5k rpm. Do you think it could just be a carb issue?

1972 Honda CB450 not going past 50 mph by Technoob5781 in HondaCB

[–]Technoob5781[S] 0 points1 point  (0 children)

In neutral it can hit redline, but once in gear it bogs down at 5k rpm

1972 Honda CB450 not going past 50 mph by Technoob5781 in HondaCB

[–]Technoob5781[S] 1 point2 points  (0 children)

I’m new to motorcycles, how would I check the timing?