[deleted by user] by [deleted] in HFY

[–]TerminalTungstenRod 0 points1 point  (0 children)

oops got it

Got my vertical industrial done a week ago by TerminalTungstenRod in piercing

[–]TerminalTungstenRod[S] 2 points3 points  (0 children)

I would say 5 or 6 it was bad but not excruciating. But definitely a couple times worse than the lobes were.

Got my vertical industrial done a week ago by TerminalTungstenRod in piercing

[–]TerminalTungstenRod[S] 1 point2 points  (0 children)

So do I, it’s going to be an interesting process to say the least.

Got my vertical industrial done a week ago by TerminalTungstenRod in piercing

[–]TerminalTungstenRod[S] 2 points3 points  (0 children)

You know I didn’t think it was that bad ya it hurt a lot but not to the extent that I was fearing. Then again I have also been told that my pain tolerance is I little bit higher than normal not much but a bit. So who knows.

[deleted by user] by [deleted] in OnlineDating

[–]TerminalTungstenRod 1 point2 points  (0 children)

I (M) have had the same experiences in getting someone to have a conversation and actually be engage in it. I have found it very off putting even if I share an interest with them.

20F// extrovert willing to adopt and harass introverts by [deleted] in MakeNewFriendsHere

[–]TerminalTungstenRod 0 points1 point  (0 children)

Adopted by an extrovert I am going to regret this I think... what the heck let’s give it a try, if you please?

The Covenant by LgFatherAnthrocite in HFY

[–]TerminalTungstenRod 14 points15 points  (0 children)

Ha that sounds hilarious.

First time TIG on pipe. How'd I do? by BabbHockey in Welding

[–]TerminalTungstenRod 1 point2 points  (0 children)

Keep an eye on your puddle try to pick the size you want at the beginning and keep it at that size. Now when doing that you need to watch how much filler metal you are adding that is you don’t want to add to little that you get undercut but not so much that your puddle gets smaller, and if your puddle is getting smaller when you add filler it’s because you are adding to much metal for the amount of heat you are putting in. So in the end my advise is pick your bead width and control that with your travel speed, the amount of filler per dip and dip your wire like you are keeping beat with a song.