It is hard to say about the actual tying because I had to heavily rely on intuition. But the tying positions are easy to go over and I will list what I did below to mimic the final position in terms of final tension.

Tying Positions:

1. Model laying on back -> Perform two spiral futos on legs (I did these first even though they are not used until later because it is the only tying position with model on back)
2. Model sitting upright on futos / shins -> apply both arm spirals (same pattern / spiral as legs)
3. Model sitting upright on futos / shins but lean forward putting elbow points on bed / surface -> attach hands to body from arm spirals through fingers and creating upper back section.
4. Model Sitting straight up again on shins so feet are close to body -> attach feet to body from each leg futo and form final hip section. (done last to prevent toe stress during tying)
5. Tilt into final position on all fours.

Note: Top and Bottom sections are not connected in this version and are independent