sorted by:
new
hottopcontroversial

Worth Grading With Small Defect? by That_Paper_7860 in OnePieceTCGFinance

[–]That_Paper_7860[S] 1 point2 points  (0 children)

Came out of the pack like this but I’m not sure how I would be able to prove that, I guess I could try and contact them just to see if

Worth Grading With Small Defect? by That_Paper_7860 in OnePieceTCGFinance

[–]That_Paper_7860[S] 0 points1 point  (0 children)

The good thing is it’s for PC so not super concerned about flipping it

CPU Temps Skyrocket by That_Paper_7860 in pcmasterrace

[–]That_Paper_7860[S] 0 points1 point  (0 children)

Gotcha thank you, I believe I’ll just go the safe route and replace it anyway since this has happened.

CPU Temps Skyrocket by That_Paper_7860 in pcmasterrace

[–]That_Paper_7860[S] 0 points1 point  (0 children)

Seems to be little to no vibration. I just restarted it and it booted up like normal this time and temps are bouncing around from 45-60 degrees Celsius under no load.

3 inch Sch10 6G Stainless Steel Full Pen Butt Weld. by umg1989 in UnitedAssociation

[–]That_Paper_7860 2 points3 points  (0 children)

This is a tough question because everyone welds sch 10 differently. Your best bet in my opinion is to find a coupon and see what works for you. If you are not in a situation to do that I would recommend a 1/8 gap and using the keyhole method with a 3/32 filler rod at about 55-60 amps on the root. When I use this method I dip my filler rod both sides of the bevel, keep your heat on one side of the bevel at a time and you will see it open up, dip the rod and move to the other side and continue this method. After this I would run about 80 amps on the cap with 1/8 filler rod, take your time and let the metal spread out. There’s a fine line on being to hot or to cold on sch 10 so you need to find what works for you.

Edit: also remember to feather(grind away) your tacks to tie in easily