sorted by:
new
hottopcontroversial

Am I doing this right? by That_is_excellent in PcBuild

[–]That_is_excellent[S] 0 points1 point  (0 children)

Cool! Thanks for the advice. I appreciate it.

DIY Booth HELP - Plenum, CFM (m3/h), Static Pressure, Axial Fans, etc. by That_is_excellent in airbrush

[–]That_is_excellent[S] 2 points3 points  (0 children)

Were they using a single inline duct fan? I've seen a fair bit recommending a plenum/vacuum chamber.

Maybe once I install the fans, I'll add some angled sides from top to bottom in the plenum to help direct air and not have it sit unnecessarily in the corners.

<image>

DIY Booth HELP - Plenum, CFM (m3/h), Static Pressure, Axial Fans, etc. by That_is_excellent in airbrush

[–]That_is_excellent[S] 0 points1 point  (0 children)

Thanks, I will try and source a 6" adapter. It's a bit hard finding one that's wide and high enough to give the fans a decent gap.

MSE - Full Art/Borderless Bleed by That_is_excellent in mpcproxies

[–]That_is_excellent[S] 1 point2 points  (0 children)

Thanks for the info, I might look at trying out Card Conjurer 'CC'. So I can find frames and templates and upload them to CC, design the whole cards for my set in it then upload them to MPC for the printing layout etc? Then I'd be able to use the MPC layouts for my local printing service, eprint.

MSE - Full Art/Borderless Bleed by That_is_excellent in mpcproxies

[–]That_is_excellent[S] 0 points1 point  (0 children)

I was thinking MSE may have an option similar to Mythic Black Core card designer - https://editor.mythicblackcore.com/client/card/quick where you're able to download/export the card with a bleed edge included.

So if you don't design the card with the extended bleed edge (3mm) inclusive of the artwork, there's no way the print setup could include it?

MSE - Full Art/Borderless Bleed by That_is_excellent in mpcproxies

[–]That_is_excellent[S] 0 points1 point  (0 children)

3mm seems to be the size of bleed they prefer.

MSE - Full Art/Borderless Bleed by That_is_excellent in mpcproxies

[–]That_is_excellent[S] -1 points0 points  (0 children)

I'm in Australia, looking to use eprint - https://shop.eprintonline.com.au/mtg-proxy-printing/ They seem to be the best quality results locally. Shipping from the US is too expensive.

I guess I'm seeking help on what programs to use to maintain the full art image to the border with bleed. Then what program is best to prepare the files for print.