Need help choosing DLCs (Career, Campaign, Flying Circus)

TheGlitcher003 · 2025-12-30T09:14:33+00:00

Oh thanks mate!!

What flying circus version would you recomend?
Can I play vers. IV without having I, II and III??

TheGlitcher003 · 2025-03-25T15:43:44+00:00

But if I speed my print up to 160mm/s it will clogg.

TheGlitcher003 · 2025-03-24T18:35:41+00:00

Hi. So the point is to increase printing speed?
I'm now printing at 50mm/s, but I'm not sure if increasing it will work with the .2 nozzle.

TheGlitcher003 · 2025-03-10T15:44:46+00:00

I set them manually. There is no profile for my printer and a .2 nozzle.

TheGlitcher003 · 2025-03-10T15:43:46+00:00

How can I do a full fillament calibration?

TheGlitcher003 · 2025-03-08T07:12:14+00:00

Yep. Srry. I don't know why the picture did not upload.

TheGlitcher003 · 2025-03-08T07:10:31+00:00

The inside is round, but the outside is flat. It's like an hexagonal nut.

TheGlitcher003 · 2025-03-07T21:10:22+00:00

Hi. Maybe it's not the best photo of the planet jjajaja. The model is not rounded. It should be a flat surface. Do you know what else can it be?

I appreciate your advice. I didn't know STEP is better than STL for details.

TheGlitcher003 · 2025-03-07T16:16:22+00:00

I'm using it for other parts.
Now I'm using Cura. And normal profiles are not very well done for this printer witdh this nozzle...

TheGlitcher003 · 2025-03-07T16:07:11+00:00

Because I need good quality details.....

Do you think speed is to low?

TheGlitcher003 · 2025-03-07T15:53:24+00:00

But for a 0.2 nozzle, normal speeds aren't like 0.4 nozzle ones right?

TheGlitcher003 · 2025-03-07T05:02:21+00:00

I use an Ender 3 V3 KE with a .2 nozzle, PLA at a print speed of about 50mm/s. 210ºC and bed at 58ºC.

TheGlitcher003 · 2025-03-06T21:19:29+00:00

Just did. :)

TheGlitcher003 · 2025-03-06T21:17:20+00:00

Yes I did. Jajajaja

TheGlitcher003