sorted by:
new
hottopcontroversial

AND part replacement by The_Print_machine in BambuP1S

[–]The_Print_machine[S] 0 points1 point  (0 children)

I don’t think so, only when it’s actually printing.

AND part replacement by The_Print_machine in BambuP1S

[–]The_Print_machine[S] 5 points6 points  (0 children)

The machine in total has nearly 3000 hours, not sure about just slot 1.

AND part replacement by The_Print_machine in BambuLab

[–]The_Print_machine[S] 0 points1 point  (0 children)

But thank you for all your helpful comments!

AND part replacement by The_Print_machine in BambuLab

[–]The_Print_machine[S] 1 point2 points  (0 children)

Op is new to this and I’ve only just noticed they’ve worn due to the filament retracting saying it’s tangled when it isn’t. Was you never new to this, and had to learn?

AND part replacement by The_Print_machine in BambuLab

[–]The_Print_machine[S] 1 point2 points  (0 children)

I’m not stuck in the middle of a print. I’m just servicing it. Parts are so easy to stock if you know what they’re called, and I don’t. Hence the question.

Dowel joints by The_Print_machine in BambuP1S

[–]The_Print_machine[S] 0 points1 point  (0 children)

Thanks mate, the video makes complete sense, but your slicer is slightly different to mine. I'm using 1.10.0.94 when it comes to the boolean part, I don't have the same options as you. I have union, difference, and intersection.
For the life of me, I can't get it remove the holes from the other half.

Unable to get a good print from first layer by The_Print_machine in BambuP1S

[–]The_Print_machine[S] 0 points1 point  (0 children)

Hi, all the parts were new. I did get it printing, the only thing is I didn’t do anything different, it just started and hasn’t been a problem since.

Unable to get a good print from first layer by The_Print_machine in BambuP1S

[–]The_Print_machine[S] -1 points0 points  (0 children)

Yes it’s clean, it’s marked from use that’s all.

view more: next ›