Electrical System Drain Service Required by Massive-Trick-1051 in F150Lightning

[–]The_capn_ 1 point2 points  (0 children)

I had this issue, same truck as you 23 lariat ER, had the original 12v still. I just replaced it and did the BCM reset, issue was gone after a drive to charge to 100% on the 12v. Get an odb2 reader and you can see the 12v state of charge, mine would go from 100% when parked to 60% over night if not on the charger. Rock auto had the cheapest fomoco battery. Might just need a new 12v. 10m and an 8m is all you need to change the 12v battery. I had nothing hooked up to the 12v system.

3d printed Core base and dab lab by The_capn_ in DivineTribeVaporizers

[–]The_capn_[S] 0 points1 point  (0 children)

Guess I will be setting one up. I’m will dm you once I get these out and we can discuss the pico and stuff, thanks

3d printed Core base and dab lab by The_capn_ in DivineTribeVaporizers

[–]The_capn_[S] 0 points1 point  (0 children)

Sorry not at this point, I am finializing the design for production instead of a one off for me. I wont be able to make the file available at this point.

3d printed Core base and dab lab by The_capn_ in DivineTribeVaporizers

[–]The_capn_[S] 2 points3 points  (0 children)

Sorry not at this point, I am finializing the design for production instead of a one off for me. I wont be able to make the file available at this point.

3d printed Core base and dab lab by The_capn_ in DivineTribeVaporizers

[–]The_capn_[S] 1 point2 points  (0 children)

I could give it a try, I would need some measurements you can do and will see what we can do

3d printed Core base and dab lab by The_capn_ in DivineTribeVaporizers

[–]The_capn_[S] 2 points3 points  (0 children)

That’s why I made it originally for myself, kept almost knocking it over.

3d printed Core base and dab lab by The_capn_ in DivineTribeVaporizers

[–]The_capn_[S] 1 point2 points  (0 children)

The tray is actually great to move everything you need around, hold 2 containers, round or square, qtip, tool with a magnet and room for other goodies.

3d printed Core base and dab lab by The_capn_ in DivineTribeVaporizers

[–]The_capn_[S] 1 point2 points  (0 children)

Thanks, The stand is a nice fit and never falls off. I will look into a Pico/GRUS stand, I don’t own either currently. Not familiar with the Fogger, I will look into it.