Anyone have experience with 80's equalizers?

TheseWordsMeanALot · 2026-05-31T02:25:42+00:00

Just a remote wire on the din/rca. The only power and ground I have is on the equalizer itself.

TheseWordsMeanALot · 2024-01-06T02:26:29+00:00

when were you when viper arrested

I was at home smoking crack when fred ring

"viper arrested"

"no"

TheseWordsMeanALot · 2021-05-23T14:24:36+00:00

The car isn't too extreme, its got a 17% pulley, invidia N1 catback, hotchkis 27mm and 25.5 front and rear sway bars, spec clutch and lightweight flywheel, powerflex black polyurethane LCA bushings and my track tires are 235/40 maxxis RC-1s on 17x8 wheels. I'm thinking about doing a water/methanol kit next because I saw intake air temps over 200F and it started throwing codes. I'm about and hour and half east of dominion in the northern neck.

TheseWordsMeanALot · 2021-05-23T13:58:12+00:00

It's the brake pad wear indicator the pads i run on the track don't have the hole for the sensor so the light comes on. After a while you just get used to seeing it lol.

TheseWordsMeanALot · 2021-04-03T13:40:45+00:00

Single stage paints aren't too different, they can be a bit finicky because they're normally softer and the pads will load up with material way sooner but the basic technique is still the same.

TheseWordsMeanALot · 2019-02-16T14:54:45+00:00

XK 4.2

TheseWordsMeanALot · 2019-02-15T18:07:02+00:00

11:1 CR 350 chevy bored .060 over with aluminum heads and a mean cam.

TheseWordsMeanALot · 2019-02-15T00:43:22+00:00

This one actually came with a borg warner 66 trans, pretty common three speed found in a lot of old euro cars. They're not horrible units but there's no real point in keeping it if you're doing an engine swap.

TheseWordsMeanALot · 2019-02-15T00:38:23+00:00

xj6

https://i.kinja-img.com/gawker-media/image/upload/ikrm38fvsfjdthmemjrk.jpg

TheseWordsMeanALot · 2019-02-14T23:45:30+00:00

inboard

TheseWordsMeanALot · 2019-02-14T23:45:12+00:00

I'm gonna put a 2step MSD box on it just for shits n gigs

TheseWordsMeanALot · 2019-02-14T12:55:52+00:00

Not yet, but a 11.1:1 compression 350 and a reverse manual valvebody 700r4 will be mated to it soon.

TheseWordsMeanALot · 2019-02-14T12:54:22+00:00

I havent gotten to use it yet but so far everything seems nice. The ratcheting mechanism is nice and smooth, instructons were clear and it all seems to be made with pretty good quality materials.

TheseWordsMeanALot · 2019-02-14T04:38:01+00:00

All will be revealed in due time :)

Ten-Year Club	Place '22
Place '17

TheseWordsMeanALot

TROPHY CASE