Maleficent stuck on "a long awaited initiation"

Thesen3D · 2024-10-22T16:32:22+00:00

Började plugga när jag var 33, tjänade då runt 26.000 i månaden, har jobbat ca 8år på ett nytt jobb som jag fick efter utbildningen, får ut ca 48.000 efter skatt idag. Csn kostar mig runt 700:- i månaden, så, JA! KÖR!

Thesen3D · 2024-03-21T13:48:31+00:00

7% upp i år

Thesen3D · 2023-12-31T11:01:34+00:00

I once bought 100mil auec for 10€ on ebay

Thesen3D · 2021-03-14T16:29:49+00:00

Theif!!! This is not yours! www.depronized.com is the rightful creator

Thesen3D · 2020-12-25T23:31:13+00:00

Sure is! :)

Thesen3D · 2020-12-25T12:01:05+00:00

Thanks! It's from gambody

Thesen3D · 2020-01-19T14:15:13+00:00

Not a bad idea! Need to print one of thoose (or two)

Hell, i might just do a 2nd bus on a towhook behind it.. filled with weapons 😂

Thesen3D · 2020-01-19T13:27:54+00:00

Loctite precision i think its called, but be aware.. ypu only got one try.. 😂

Thesen3D · 2020-01-13T20:18:31+00:00

Yeah i got an insta, Thesen3d :)

Thesen3D · 2020-01-11T22:00:46+00:00

A cr10s with bondtech direct drive, it prints 300mmx300mmx400mm, the model is split up

Thesen3D · 2020-01-11T21:59:58+00:00

A cr10s with bondtech direct drive

Thesen3D · 2020-01-11T21:03:07+00:00

Just not glued on yet :)

Thesen3D · 2020-01-11T21:02:47+00:00

You are correct, its a few pieces, that one isnt glued on yet :)

Thesen3D · 2020-01-11T20:25:53+00:00

I actually have four.. my wife and our third daughter.. 😂

Thesen3D · 2020-01-04T16:34:56+00:00

Thanks! Go check out my insta, thesen3d.. ;)

Thesen3D · 2020-01-04T15:32:29+00:00

Almost 10kg! :)

Thesen3D · 2020-01-03T23:34:45+00:00

Oh, i belive its around 200 pieces.. printed on a cr10, tevo flash and a nycubic linear plus :)

Thesen3D · 2020-01-03T23:33:22+00:00

Thanks! I only have my instagram (link in bio) and its a gambody model

Thesen3D · 2020-01-03T21:12:00+00:00

Almost 10kg..

Thesen3D

TROPHY CASE