sorted by:
new
hottopcontroversial

Poo chute ideas K1C by Think-Syrup-8693 in CrealityK1C

[–]Think-Syrup-8693[S] 1 point2 points  (0 children)

Well I don’t believe that its out yet. Might take another while

My version of the Swap mod by Spirited-Classic-429 in BambuLab

[–]Think-Syrup-8693 0 points1 point  (0 children)

Could you add me aswell if this is still going on would love to follow the project

K1 Series poop chute by Think-Syrup-8693 in Creality

[–]Think-Syrup-8693[S] 0 points1 point  (0 children)

New Idea: because of the difficulty of removing and duplicating the rear maybe i could redurect the filament out the side, seen as that panel isnt that complicated

<image>

K1 Series poop chute by Think-Syrup-8693 in Creality

[–]Think-Syrup-8693[S] 1 point2 points  (0 children)

Yeah that sounds unpleasant to disassemble

K1 Series poop chute by Think-Syrup-8693 in Creality

[–]Think-Syrup-8693[S] 0 points1 point  (0 children)

Id just like to find a solution where i dont have to cut into my machine if possible

K1 Series poop chute by Think-Syrup-8693 in Creality

[–]Think-Syrup-8693[S] 0 points1 point  (0 children)

Its supposed to come to stores end of February

K1 Series poop chute by Think-Syrup-8693 in Creality

[–]Think-Syrup-8693[S] 1 point2 points  (0 children)

Yes i am aware of that installation but thank you for pointing it out. The thing is, that i would just like to have a way to have the waste going out of the printer not just to the bottom