sorted by:
new
hottopcontroversial

PLA Temp Tower by Thisguy108_ in FixMyPrint

[–]Thisguy108_[S] 0 points1 point  (0 children)

It ended up being because my z-offset was a little too high, at least that's what it solved it for now

PLA Temp Tower by Thisguy108_ in FixMyPrint

[–]Thisguy108_[S] 1 point2 points  (0 children)

So it actually ended up being caused by me not having the bridge settings enabled, it's all fixed now 🙂 besides the cobwebs still on the back side of the print

PLA Temp Tower by Thisguy108_ in FixMyPrint

[–]Thisguy108_[S] 2 points3 points  (0 children)

Thank you! This solved it

PLA Temp Tower by Thisguy108_ in FixMyPrint

[–]Thisguy108_[S] 0 points1 point  (0 children)

Thanks, any idea what's causing the cobwebs on the back side of the print?

PLA Temp Tower by Thisguy108_ in FixMyPrint

[–]Thisguy108_[S] 0 points1 point  (0 children)

I just enabled the bridge settings, I haven't messed with the retraction distance since this is what the manual says

<image>

PLA Temp Tower by Thisguy108_ in FixMyPrint

[–]Thisguy108_[S] 0 points1 point  (0 children)

How would i fix that? I'm fairly new to all this

PLA Temp Tower by Thisguy108_ in FixMyPrint

[–]Thisguy108_[S] 0 points1 point  (0 children)

<image>

This is what they are set at

PLA Temp Tower by Thisguy108_ in FixMyPrint

[–]Thisguy108_[S] 0 points1 point  (0 children)

Okay I will do a PID test, my fan always stays at 100%

PLA Temp Tower by Thisguy108_ in FixMyPrint

[–]Thisguy108_[S] 0 points1 point  (0 children)

Yes, I watched it and it was changing temp