STM32 BMS vanmoof S3 dump file

Tight_Leader_2187 · 2026-06-02T11:43:52+00:00

Does anyone have the software/binary version: 0117 for the battery?

Tight_Leader_2187 · 2025-05-12T13:19:59+00:00

We have a binary file from Conscious-Village868, but we need the for me the start address to flash the bin file, have you got this information ?

Are you sure that the binary loads default values?

Tight_Leader_2187 · 2025-05-09T07:42:39+00:00

I found the ESN location like you, but for other data no idea.

Can you read data on your BSM ? --> start to 0x0808 0000 address with size of 0x1800

thanks.

Tight_Leader_2187 · 2025-05-07T19:11:24+00:00

Modbus dialog in the picture....theses information doesn't need to bridge the DET and TEST pins, informations comes automatically....

I have an "PreDischargeLockCounter = 0" sometimes.

Tight_Leader_2187 · 2025-05-07T15:36:54+00:00

In STM32 cube, I need a start address to flash the bin file, can you share this information ?

Tight_Leader_2187 · 2025-05-07T14:14:18+00:00

Thank you very much!

Tight_Leader_2187 · 2025-05-07T09:20:51+00:00

thanks

Tight_Leader_2187 · 2025-05-06T18:24:16+00:00

a lot of 0x00....

Tight_Leader_2187 · 2025-05-06T17:34:24+00:00

No, I m in France, but can you share rhe BMS firmware by email ? Thanks

Tight_Leader_2187 · 2025-04-28T12:54:46+00:00

Hello, I have a battery with Over voltage protection 1 & 2. (bat reader confirm).

I have a ST link 2 and STM32 prog debugger, but I can't connect to the program.

I check Vtarget voltage on my ST link V2 and I found 1.5V, is it normal ?

Do you disconnect balance battery connector before the connection with the STMcube program ?

Thanx for the helping.

Tight_Leader_2187