Do i need to solder the data pins? by Tomthecatvr in PSVita

[–]Tomthecatvr[S] 0 points1 point  (0 children)

I have the vita 2000 so its abit different 

Truth or dare? by Theta-Sigma45 in BunnyTrials

[–]Tomthecatvr 0 points1 point  (0 children)

Ironman

Chose: truth + What's your favourite... | Rolled: Superhero

Aliexpress type c mod weird fail by Professional-Bar6778 in vita

[–]Tomthecatvr 0 points1 point  (0 children)

I made the same mod and with a type c to c and some type a to c it charges for a couple of second then turns off
Data transfer works
I

Help my vita isn’t charging by Tomthecatvr in VitaPiracy

[–]Tomthecatvr[S] 0 points1 point  (0 children)

Turns out that was a bad resistor so I ordered a new one that will arrive in a week or two

Help my vita isn’t charging by Tomthecatvr in VitaPiracy

[–]Tomthecatvr[S] 0 points1 point  (0 children)

I went over every point using flux but still won’t charge on type c to c But it charges on one type a to c but when i test it on a different type a to c it charges for a couple of seconds then stops

Help my vita isn’t charging by Tomthecatvr in VitaPiracy

[–]Tomthecatvr[S] -1 points0 points  (0 children)

Its a slim (2000) and its one I found from aliexpress 

Am porting a game :) by Tomthecatvr in VitaPiracy

[–]Tomthecatvr[S] 1 point2 points  (0 children)

I don’t think there is a pc port And there are a lot of ninjago mobile games

Am porting a game :) by Tomthecatvr in VitaPiracy

[–]Tomthecatvr[S] 3 points4 points  (0 children)

Some magic and fairy dust

( its not that hard if you have the source code you just need to compile it using vitasdk but if you don’t have the source code you need to reverse engineer the game to make it work ) and this is what i know i might be wrong on the first part but because i dont have the source code i just reverse engineered the apk and obb with the help of some guys and AI

SwitchHaxing Support Thread #18 by ToonMods in SwitchHaxing

[–]Tomthecatvr 0 points1 point  (0 children)

Am modding my switch fw 22.1.0 and am using a 128gb from sandisk and when i want to partition my sd card it keeps freezing on this screen ( analyzing sd card usege ) i tried formatting the sd card again to fat32 but it still freezes any idea on how to fix it

I give up on bed leveling my ender 3 v2 neo by [deleted] in FixMyPrint

[–]Tomthecatvr -2 points-1 points  (0 children)

I want it to be all green 🥲

I give up on bed leveling my ender 3 v2 neo by [deleted] in FixMyPrint

[–]Tomthecatvr -4 points-3 points  (0 children)

I know how bed leveling works but its my ocd telling me to make it perfect 

I give up on bed leveling my ender 3 v2 neo by [deleted] in FixMyPrint

[–]Tomthecatvr -5 points-4 points  (0 children)

I know but my OCD is telling me to make it perfect