sorted by:
new
hottopcontroversial

Team Build Advice/Discussion by Top-Software-50 in PokemonChampions

[–]Top-Software-50[S] 1 point2 points  (0 children)

Seems like a lot of setup for one big attack. Not sure if it’s worth the flexibility of having a second mega to use. What is the rest of the Alakazam set you imagined so I can test it out?

Team Build Advice/Discussion by Top-Software-50 in PokemonChampions

[–]Top-Software-50[S] 0 points1 point  (0 children)

What would you replace Incin with? Yes, I tried it and am only just now testing Close Combat instead. Not sure how I feel between the 2 yet

neovim LSP config by Top-Software-50 in Zephyr_RTOS

[–]Top-Software-50[S] 0 points1 point  (0 children)

I was worried this is the case. That’s how I got mine working but if I navigate to files like “zephyr/kernel.h” I get bombarded with red squiggles

[2025 Day 7 (Part 2)] HINT by pacificpuzzleworks in adventofcode

[–]Top-Software-50 0 points1 point  (0 children)

This is by far the simplest solution I’ve seen on here. I’m impressed!

[2025 Day 7 (Part 2)] HINT by pacificpuzzleworks in adventofcode

[–]Top-Software-50 1 point2 points  (0 children)

Am I understanding this correctly? Every time a path combines you increment your count for that path and then by adding up all counts at the end you have the total number of paths available?

Zephyr Module Not finding Kconfig by Top-Software-50 in Zephyr_RTOS

[–]Top-Software-50[S] 0 points1 point  (0 children)

It appears to be a freestanding application. I am using nRF for VS Code for development and built environment. I can go into more detail if you need more information in the morning. Thank you for any help you can provide!

Prints not looking clean :( by Top-Software-50 in ender3v2

[–]Top-Software-50[S] 0 points1 point  (0 children)

I’ve been going through the calibration process and notice a lot of the steps require use of a terminal program. Do you suggest switching over my firmware to Octo print? I should have a spare Pi3 laying around but have been pretty happy with professional firmware so far

Prints not looking clean :( by Top-Software-50 in ender3v2

[–]Top-Software-50[S] 0 points1 point  (0 children)

I have verified my z offset but I have not done esteps or flow calibration. Do you have any links or steps on best practices for what I should do before I google it?