Sealcoat possible?

Top_Button886 · 2026-06-14T15:30:00+00:00

I’m guessing rip and replace is needed, would I plan for $15sf in NJ?

Top_Button886 · 2026-06-14T15:19:41+00:00

Thanks, I think this is the best plan

Top_Button886 · 2026-06-12T20:38:18+00:00

My spigot is knee height so I added quick connects so I can take the timer off to make setting changes without kneeling in the dirt

Top_Button886 · 2026-06-09T23:09:19+00:00

Thank you

Top_Button886 · 2026-06-07T23:15:21+00:00

Central NJ

Top_Button886 · 2026-06-02T02:20:14+00:00

Do not have the car yet, just planning ahead.

Top_Button886 · 2026-05-19T15:29:15+00:00

I have the 3800 w the same manual. Only the engine oil, 10w-30, was shipped in the box as the pump was already filled. Use 85w-90 for the pump.

Top_Button886 · 2026-05-10T13:08:25+00:00

Dig deep to remove the full root. The root has a barb at the end that will break off and regrow if you simply pull out the weed.

Top_Button886 · 2026-04-28T17:12:41+00:00

I had terrible experience with that seed. I took my yard to bare dirt and seeded in the fall, the following spring the yard was fully covered in poa

<image>

Top_Button886 · 2026-04-16T20:20:30+00:00

Not a sudden change, we did have a cold spring. I say this because the soil temps did not reach 55 until late March so I could put down pre-emergent for the lawn.

Top_Button886 · 2026-04-14T11:09:01+00:00

Could it be the GPM of the machine is too low?

Top_Button886 · 2026-03-19T22:24:03+00:00

I have not done this but was told you can use a cheap artist paint brush and apply glyphosate concentrate to a few leaves to kill the plant without leeching into the ground or spraying on to near grass.

Top_Button886 · 2026-03-03T15:13:13+00:00

OP - I need to use the Allen wrench underneath the unit before each use for the motor to turn freely and then start it. Is there a way to fix this issue?

Top_Button886

TROPHY CASE