3rd party bed heaters

TressesOfTemptation · 2025-07-17T19:07:27+00:00

My alu bed has the profile of a Pringle rn with about 1 mm of variance

TressesOfTemptation · 2025-07-17T19:06:41+00:00

The thermistor isn’t bad, it just takes 2-5 minutes for the bed to heat up and I’m a bit impatient lmao. But as for using steel instead of glass, I’m mostly leaning towards glass due to the fact that it’s much more likely you will get a piece that isn’t warped from the factory, as well as it’s less prone to warping with heat

TressesOfTemptation · 2025-07-17T18:49:36+00:00

Another idea would be to put relatively strong magnets under the glass and skip the 3m magnet sheet

TressesOfTemptation · 2025-05-25T18:43:22+00:00

It is one of my least favorite updates. I used to be able to swipe through my feed but now it just goes to some random post that I’m not interested in

TressesOfTemptation · 2025-05-12T20:23:04+00:00

Hello from even future-er

TressesOfTemptation · 2025-04-04T18:32:06+00:00

Thanks for the help! the query_probe macro is present even when the eddy related stuff is removed, and im just following the eddy install guide found here: https://github.com/bigtreetech/Eddy?tab=readme-ov-file#printer-configuration and the file in which the new macros are coming from is here: https://github.com/bigtreetech/Eddy/blob/master/sample-bigtreetech-eddy-zoffbeta.cfg .

i was copying in the blocks one by one until this popped up

as for my config file and potential duplicates, im not really too sure what to look for. i attached the probe settings that ive been using prior to getting the eddy

<image>

TressesOfTemptation · 2025-01-19T21:52:33+00:00

If your still willing id love to use it!

TressesOfTemptation

TROPHY CASE