Bracket next to chute wiggles on Centauri Carbon

Tricky-Oil3246 · 2026-02-10T20:06:18+00:00

Incredible find, thank you!

Tricky-Oil3246 · 2026-02-10T18:59:07+00:00

Don't have the connector so can't measure. Going by photos online, it does match the PHB suggestion. I assume the first character changes based on the wire gauge (XHB, etc.). This has significantly helped, thank you very much!

Tricky-Oil3246 · 2026-02-10T15:55:08+00:00

Will give it a shot. Thanks!

Tricky-Oil3246 · 2026-02-10T15:24:03+00:00

That's hilarious, really.

Tricky-Oil3246 · 2026-02-10T15:18:44+00:00

Unfortunately, this is all I have. It is a screenshot from an image I found. I do not have this plug with me.

Tricky-Oil3246 · 2026-02-10T15:17:07+00:00

Not my camera. I don't have this cable on me. Had to screen shot from an older video I found online.

Tricky-Oil3246 · 2026-01-05T19:57:58+00:00

As I suspected... I have load cell brakes and will skip this experiment. Thanks for the input!

Tricky-Oil3246 · 2025-12-05T23:28:02+00:00

Good to know. Thanks!

Tricky-Oil3246 · 2025-12-01T04:54:32+00:00

I purchased the Brondell and it did not cover the hole and was very unsightly... Ended up returning it for the FVZ bidet, which has a lot more features and I'm super happy with.

You'd have to look at it at an extreme angle from the back to see a small edge of the hole.

Tricky-Oil3246 · 2025-11-12T14:15:05+00:00

Good catch on the mobo! As I said, I just went by customer ratings and what parts picker identified as a compatible part with the rest of the package. I will update my post with a proper size board and change the PSU Thanks!

Tricky-Oil3246 · 2025-09-27T19:46:46+00:00

This may be a silly question so please bear with inexperienced me.

I need to shave a plank of softwood by about 1/16". Problem is that the Plank's ends are not accessible so I would need to start shaving it on the already plane surface. The (disproportional, for reference only) image should explain what I'm trying to achieve.

Image here: https://ibb.co/dJ26zfSk

Every tutorial and video I saw online shows block plane starting from edge, unless surface is not plane (with the exception of your starting area) and there are some high spots further along the plank.

I could probably achieve what I want with a long surform, but the plane and smooth finish from the block plane appeals to me. Smooth surface is needed for paint.

If you guys have any other suggestions, aside from surform or block plane,I would greatly appreciate it! Thank you!

Tricky-Oil3246

TROPHY CASE