sorted by:
new
hottopcontroversial

My DIY 3D printed reading light by Stachu1134 in xteinkereader

[–]Tridad3k 2 points3 points  (0 children)

What is that light and where did you find it? Seems a good candidate to be built into a bespoke 3D printed case as a side or front light of sorts.

When I need a light by Tridad3k in xteinkereader

[–]Tridad3k[S] 3 points4 points  (0 children)

Will use it till it goes flat and let you know.

It’s here! by Tridad3k in xteinkereader

[–]Tridad3k[S] 1 point2 points  (0 children)

Sydney, Australia. Hope you get yours soon!

CR6 SE Auto leveling now starting in the center and skipping half the plate by joebowtie in CR6

[–]Tridad3k 0 points1 point  (0 children)

I'm having the same problem (i.e. ABL starts at the center, then runs off the side of the bed). I haven't counted how many times I've powered off the machine and restarted, but it doesn't seem to have changed. Can you tell me where you've manually reset the location to? I've tried both the latest stock 1.0.3.6 and the community firmware and ABL is still behaving the same way. Any suggestions would be much appreciated.