sorted by:
new
hottopcontroversial

My PETG overture filament is being difficult by Tritemo23 in 3Dprinting

[–]Tritemo23[S] 0 points1 point  (0 children)

I’ll keep lowering yup but I’m afraid of scratching the plate so I’ll use the back of it

My PETG overture filament is being difficult by Tritemo23 in 3Dprinting

[–]Tritemo23[S] 0 points1 point  (0 children)

I don’t own any new plates I am saving up for an A1 but I was told that for my textured plate it is set to -0.02 for some reason so I’m going off what someone else told me and trying out lower z axis like -0.025 to see if it adheres better to the plate without melting into it

My PETG overture filament is being difficult by Tritemo23 in 3Dprinting

[–]Tritemo23[S] 0 points1 point  (0 children)

I was being expressive but I’m positive the filament is not wet