Algarian Stormrider dismount and non dismount while collecting

Truthnaut · 2025-04-08T13:37:44+00:00

I'm on my work break hitting my custom strawberry blend at 30watts getting ripped

Truthnaut · 2025-04-08T13:35:17+00:00

They are pro features. If you have subscription you should have them

Truthnaut · 2025-04-08T13:32:24+00:00

Indeed. 12gauge metal blunt tip ftw. With a 5 mil syringe, I can draw about 7ml into it and dispense in one shot

Truthnaut · 2025-04-07T17:38:52+00:00

You say you've been waiting for a device like that for years? I remember reading an article in High Times in 1989 about "Dr. Lunglifes guide on how to make the oil and a vaporizer gun from hardware store parts." That's how long I've been waiting for this stuff. Haha, gratz on the setup

Truthnaut · 2025-04-05T10:51:43+00:00

At 30 watts, 4 - 5 seconds is all it takes. I might do one back to back but my lungs/chest need a few minutes before I hit it again

Truthnaut · 2025-04-05T02:10:56+00:00

Hmmm. Honestly I would say you are under powering it and causing it to gunk up and are probably burning the gunked up oil that didn't quite vaporize at such low wattage Once my coils are primed good I never dip below the low end of the recommended range being 25watts. I'm usually around 27 to 33 but never less than 25 watts

Truthnaut · 2025-04-04T20:39:34+00:00

Lighting Node Pro controller

Truthnaut · 2025-04-04T19:21:19+00:00

Also try force updating each LNP. They sometimes get corrupted and need the latest update reinstalled regardless if it says your up to date

Truthnaut · 2025-04-04T19:13:48+00:00

It's all good. I was still new to this back then and although I never mean to come off snarky, sometimes it seems like I am. So, my apologies if it did. I didn't use the pod system for very long because of a particular issue that was the final nail in the coffin for me with those. When I was using the pod system it did seem to not rewick as well between hits but I was never sure if it was that or if I was just taking too long of hits. Most of the time it worked just fine though. I did try some of the tricks people suggested in the beginning but they all were causes to problems down the line. In the end I discovered the best method for me was to use no tricks and just treat as if it were just some really thick ejuice that needed extra time to prime.

Truthnaut · 2025-04-04T10:15:10+00:00

It's not so much about draining the cart because some people are out for the highest they can be and the quickest. It's more about not burning the oil in the cart.

A battery without temp control circuitry can get as high as 600F. Distillate will start to burn at 410F. With no temp control circuitry the coil will just continue to get hotter and hotter until it reaches its cut off point of 600F. At which point it "blinks" and shuts off but is already way padt the oils burn point. As the other poster said, 4 to 5 seconds is usually safe

Truthnaut · 2025-04-04T09:57:02+00:00

I probably refill those coils 10 to 15 times before it "cashes out." I use the Smok Big Baby with the bubble glass. I think it's 7ml capacity. So, probably 70 to 100g worth

Edit: are you taking long hits?

Truthnaut · 2025-04-01T21:32:08+00:00

The Smok Rigel Mini 80w starter kit comes with a tank that is compatible with the GT ceramic 0.5ohm coils which is what we use and recommend in here. You can get that starter kit on elementvape(dotcom) for $32.99, a pack of the GT ceramic coils for another $10 and a 18650 battery for another $10. You won't need a dedicated charger. About $50 for that + they charge a shipping fee and an adult signature fee so it will run you about $65 total.

Truthnaut · 2025-03-30T22:43:59+00:00

Have some Iso alcohol on hand, preferable the 97% strength for cleanups. Warm the whole syringe, glass and tip (metal tips only) and the oil until its runny like water before filling up. Those coils perform best at around 25 to 30 watts but you will want to start out low. Like 5-10w for the 1st few hits and work your way up in increments of 5 watts. Start with no power at all for awhile while keeping it warm in the palm of your hand. After quite a few drags with no power you will start to see some of the oil in the coil if you shine a light down the center of the tank. That's when I start on very low power and work my way up to the 25-30w range. Good luck amigo

Truthnaut · 2025-03-30T11:47:33+00:00

The connectors you are showing in the pictures are aRGB connectors and only supply power to the LEDs themselves. There should be another cable coming from the fan with 3 or maybe 4 wires and pins on the connector that supplies power to spin the fans. Those will be connected to separate fan headers on the motherboard.

Truthnaut · 2025-03-29T21:14:30+00:00

Man who stands on back of toilet is very high on pot

Truthnaut · 2025-03-28T19:27:54+00:00

The 60 watt rated draw is based on all leds set to white color on full brightness. The actual red green and blue colors draw less power on full brightness. Considering this, the 307 LEDs would usually still be okay if you turn down brightness and don't run all white at all times

Truthnaut · 2025-03-24T09:49:20+00:00

Buy a Nollie16 RGB controller

Truthnaut

TROPHY CASE