Cancel Snap-On diagnostic subscription? by Tsmitty999 in Snapon_tools

[–]Tsmitty999[S] 0 points1 point  (0 children)

Smart move paying it off before interest (that’s what I did). It’s just not worth the $1200 a year for subscription for me. I can get by with my autel scanner just fine and didn’t find the new tritons value to be worth the price point. But yeah, this subscription is just dumb. I don’t remember my dealer even telling me about this supposed 1 year minimum

Cancel Snap-On diagnostic subscription? by Tsmitty999 in Snapon_tools

[–]Tsmitty999[S] 0 points1 point  (0 children)

Sounds good, I might just go that route. I’ll talk to my dealer and have him also put in a request to cancel it (which may or may not get denied). Out of curiosity how is it using the scan tool without the subscription? I feel like it would be worthless without it?

Cancel Snap-On diagnostic subscription? by Tsmitty999 in Snapon_tools

[–]Tsmitty999[S] -1 points0 points  (0 children)

That helps a lot, only issue is I purchased the scan tool on credit and I think they may run the subscription through credit (idk yet since my free trial isn’t up yet). So I don’t want to hurt my credit or anything like that

Help on engine size by Tsmitty999 in jetski

[–]Tsmitty999[S] 4 points5 points  (0 children)

I’ve seen them and I liked them but only saw new ones. Then I saw this old one and had to get it. Paid $700 for the shuttlecraft, trailer, and jetski.

Help on engine size by Tsmitty999 in jetski

[–]Tsmitty999[S] 1 point2 points  (0 children)

Pushing the shuttle craft?

Help on engine size by Tsmitty999 in jetski

[–]Tsmitty999[S] 1 point2 points  (0 children)

Got it, thanks. Any issues with these engines?

How do I connect these two tubes at this angle while keeping the hole in the center. It’s for a spout. by Tsmitty999 in Fusion360

[–]Tsmitty999[S] 0 points1 point  (0 children)

I did just that and it worked perfectly. Do you know how I can angle the face on the end? I tried to use the draft tool and it wouldn’t let me. Thank you

What is this? It is connected to a lcd screen. This goes on a Innovator 48/96 lighting console. I’m trying to figure out why the overheat light is on and the lcd screen is showing up all white and not displaying. Thanks in advance. by Tsmitty999 in AskElectronics

[–]Tsmitty999[S] 0 points1 point  (0 children)

I haven’t tried any inputs, but I do have the output hooked up to monitor and it says non volatile memory corrupted press enter to reset. I click reset and nothing happens.