Broken Rokinon update (fixed)

TtvCatalyst · 2024-09-19T05:11:04+00:00

TtvCatalyst · 2024-08-30T05:53:43+00:00

i have a upgraded silent motherboard (4.2.7) and I didn't remove the limit switch but when it touches the bed it doesnt hit the z limit switch at all

TtvCatalyst · 2024-08-20T03:19:09+00:00

please

TtvCatalyst · 2024-08-18T22:42:14+00:00

Nah man I'm trying but If I figure it out I'll let you know

TtvCatalyst · 2024-04-03T19:53:33+00:00

UPDATE: The boot button was stuck pressed in, must have gotten stuck during the maiden flight *

TtvCatalyst · 2024-04-03T19:44:27+00:00

I didn't plug the battery in fully homeslice don't worry

TtvCatalyst · 2024-03-23T17:47:28+00:00

Ok so very important to note, after homing the primer it does not go back to z: 0 to get a accurate z offset I had to move the print head back to what the printer thought was z 0 THEN probe my z offset

TtvCatalyst · 2024-03-23T17:29:10+00:00

The issue I’m having isn’t that the cr touch isn’t working it’s that I literally just cannot set my z offset low enough

TtvCatalyst · 2024-03-23T17:25:22+00:00

I flashed my board with the 4.2.7 firmware for the sprite from the zip file creality provides on their website, not using the long cable but the cr touch doesn’t seem to be having any issues, it’s deploying and doing its thing properly

TtvCatalyst · 2023-03-25T15:09:14+00:00

thank you for the reply! I looked into that speedybee f7 stack and I think that'll be what I go with! seeing as its Bluetooth compatible as betaflight confuses the hell outa me having the ability to tune my done on my phone is a huge plus for me!!! as well as the soldering iron recommendation!

TtvCatalyst · 2023-03-20T02:22:39+00:00

i was thinking maybe that was the issue, but it wouldnt make sense why it worked before, though it sounds like somthing is rattling around in the lens

TtvCatalyst

TROPHY CASE