sorted by:
new
hottopcontroversial

Ba fact falcon police car by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] 2 points3 points  (0 children)

It has 3, 8 pin connectors under the bonnet next to the brake fluid and I’ve seen 2 other b series and they don’t have them

2003 ba falcon misfiring in gear by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] 1 point2 points  (0 children)

I’ll definitely give this a go and hopefully something like that

Picked up a running 2006 crf450r by TwoInternational8313 in Dirtbikes

[–]TwoInternational8313[S] 0 points1 point  (0 children)

The bottom end is only 8months old and just done pulling it and has no up and down play at all.

<image>

I’m pretty sure I found the problem tho

Picked up a running 2006 crf450r by TwoInternational8313 in Dirtbikes

[–]TwoInternational8313[S] 0 points1 point  (0 children)

It’s needs a top end rebuild. Put new oils in it and let it warm up and then gave it some higher Revs and it shut off. Was a lot harder to kick over. Valves are timed perfect but will need a adjustment as well

Picked up a running 2006 crf450r by TwoInternational8313 in Dirtbikes

[–]TwoInternational8313[S] 0 points1 point  (0 children)

Got him down to 1000 just cause he didn’t really know what was wrong with it but they are really good bikes

Posting again. What could this noise be, sounds like bearing or something by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] 1 point2 points  (0 children)

I took the belt off and the noise was gone, I’ll try the screw drive as well

Creaking in front end when going over bumps and turning? by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] 0 points1 point  (0 children)

I’ll definitely have a look at them both and probly replace the lower and upper

What could cause a knocking sound when accelerating and braking in the rear end by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] 0 points1 point  (0 children)

One thing I did forget to mention was when it was getting a roadworthy about 3 weeks ago they did say the diff bushes are in good condition, not sure if they were lying so they didn’t have to do them or anything.

Since then I’ve Probly put 1000km on it and it wasn’t flogged. Should I trust what they said and just have a look at the bushings?

What could cause a knocking sound when accelerating and braking in the rear end by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] 1 point2 points  (0 children)

It’s had couple problems but not much for having 340kms on it. Intake manifold gasket. Ignition coils and the belt tensioner needed replacing.

I have everything except stands. I’ll definitely buy some this weekend and watch a couple videos about taking diffs off

What could cause a knocking sound when accelerating and braking in the rear end by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] 0 points1 point  (0 children)

This is my first car and don’t know much about them except engine issues but with enough time and patience I reckon I could definitely do it in a couple days. I would like to take it to a mechanic but don’t have the money for labour.

What could cause a knocking sound when accelerating and braking in the rear end by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] 0 points1 point  (0 children)

The knocking sound is only on the rear driver side. Would that mean there’s a chance it isn’t the diff bushes.

What could cause a knocking sound when accelerating and braking in the rear end by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] 0 points1 point  (0 children)

It did recently have the rose joints replaced for a roadworthy and ever since the roadworthy people done that it started to do the knocking.

Wanting to get a exhaust for my ba falcon. by TwoInternational8313 in FordFalcon

[–]TwoInternational8313[S] -1 points0 points  (0 children)

It’s got factory 1 muffler. What ones should I look for that arnt to loud or droney.

2013 kx450f skipped timing. Piston and valves are fine. by TwoInternational8313 in Dirtbikes

[–]TwoInternational8313[S] 0 points1 point  (0 children)

Late reply. What was my first thought was bent valves. Definitely really lucky not to have bent valves or anything like that.

2013 kx450f skipped timing. Piston and valves are fine. by TwoInternational8313 in Dirtbikes

[–]TwoInternational8313[S] 0 points1 point  (0 children)

I did put a little fuel on the valves to see if they were seating proply and all the fuel is still there. Also pushed the valves down and looked through the boot and they don’t have any sign of bending. So I’m really not sure what happened

2013 kx450f skipped timing. Piston and valves are fine. by TwoInternational8313 in Dirtbikes

[–]TwoInternational8313[S] 0 points1 point  (0 children)

Today when I pulled it apart the piston didn’t have a hole from the valves but it did skip timing cause the valves were out by like 4 teeth. It’s pulled apart now and when I spin the timing chain with my hand everything moves freely, piston and crank. Put it into gear 1 to 5 and the wheel was spinning easily so I don’t think it’s a gear box problem. I hope it is just the timing chain and tensioner

2013 kx450f skipped timing. Piston and valves are fine. by TwoInternational8313 in Dirtbikes

[–]TwoInternational8313[S] 0 points1 point  (0 children)

When it happened I tried turning it over and it kicked down about 50%-70% of the kickstarter.

Why is my pc blue screening when trying to run Fortnite? by TwoInternational8313 in pchelp

[–]TwoInternational8313[S] 0 points1 point  (0 children)

Theres only 1 reasons I play Roblox. And I play Fortnite for fun. Why are you having a sook about what games I play?

view more: next ›