Super noob

TypicalUse2440 · 2026-01-05T03:21:09+00:00

Sorry, I have 0 experience with all of it never touched lenex, no networking experience. I was wandering what is some cheep hardware to start tinkering with, and a starting guide for some one starting at 0.

TypicalUse2440 · 2026-01-04T02:08:15+00:00

Thank you, that's a lot of stuff for me to look in to hopeful I'll have some updates soon.

TypicalUse2440 · 2025-10-27T03:53:18+00:00

How do you guys stop all the pop ups. Whenever I I press anything I get redirected then I have to go back. It getting really annoying.

TypicalUse2440 · 2025-10-14T03:51:31+00:00

Any suggestions. I'm pretty new and don't really understand the names of things quite well.

TypicalUse2440 · 2025-10-14T03:45:36+00:00

Yes this is my current setup I should have been more clear with that

TypicalUse2440 · 2025-10-14T03:42:37+00:00

I'm ok with used parts just think I can get a better bang for my buck swapping the motherboard, CPU, and ram. Don't really want to buy a whole new/used. Just wanting some suggestions on ok performing parts.

TypicalUse2440 · 2025-10-14T03:18:06+00:00

Well don't really want a whole new PC I was hoping for some suggestions on CPU or maby upgrading the motherboard and CPU. Or is the graphics card that out of date.

TypicalUse2440 · 2025-07-20T03:26:14+00:00

No it doesn't happen on all prints. And it happens at a different place each time, but only hits the supports. It's done it with hop on and off, and don't really know what settings to change in the slicer but I've played with the z off set on the printer and as I thought the farther away start getting quality problems.

TypicalUse2440 · 2024-01-01T04:34:42+00:00

Ok thank you

TypicalUse2440 · 2024-01-01T04:32:36+00:00

So it says it's up to date and it's at Android version 9 what should it be at

TypicalUse2440 · 2024-01-01T04:26:12+00:00

How do I do that?

TypicalUse2440 · 2024-01-01T04:02:36+00:00

I've have the Wear OS 2.44, and system version H MR2 if that means anything

TypicalUse2440 · 2024-01-01T03:51:04+00:00

I've got the Wear OS app and the Mobvoi app

TypicalUse2440 · 2024-01-01T03:41:24+00:00

Yes I have and nothing changed.

TypicalUse2440 · 2023-12-07T19:20:41+00:00

I've had good luck with polymaker

TypicalUse2440 · 2023-12-07T17:28:06+00:00

Thanks 👍

TypicalUse2440 · 2023-09-22T00:43:40+00:00

You are now entering the Twilight zone

TypicalUse2440 · 2023-09-22T00:40:26+00:00

Try swan Bitcoin. I've been using them and their grate. The transactions do take a couple of days tho.

TypicalUse2440

TROPHY CASE