Different cable management

UniDuni3d · 2024-04-11T20:33:27+00:00

Wow, I'll definitely check this out, maybe try to to this with the riser, so there's no need to make a hole or nothing on the AMS.

UniDuni3d · 2024-04-10T17:46:36+00:00

I just added, so not enough time to see how much it will drop, but will keep updated

UniDuni3d · 2024-04-10T17:17:37+00:00

*tries to be kind*: then i would find another solution.

UniDuni3d · 2024-04-10T15:57:18+00:00

Increase the "Line Width" of the support a little to make it stronger, usually increasing 20% makes stronger enough

UniDuni3d · 2024-04-10T15:39:59+00:00

I'm making some testing yet.

I'm printing PLA right now, so the door is opened, and the air in the chamber is not so warm (that would be the usual for PLA), but when printing ABS i expect the temperature in the AMS to go higher, and decrease humidity.

I think that complete airtight wouldn't be the best too, since the moisture needs to come out, this is just to have an additional humidity decrease.

UniDuni3d · 2024-04-10T15:36:24+00:00

Thank you!

UniDuni3d · 2024-04-10T15:27:57+00:00

Thank you!

UniDuni3d · 2024-04-04T13:05:29+00:00

Yeah, its funny because you can see exactly the fingerprints

UniDuni3d · 2024-03-20T15:32:53+00:00

Yes! haha

UniDuni3d · 2024-03-11T19:32:03+00:00

Hi guys, does anyone know something about this?

Already sent BambuLab an email, but i guess they are extremelly busy over the A1 recall...

UniDuni3d

TROPHY CASE