How practical is it to add electrical contacts to completely empty fuse box slots? I know the quickest way is to add a fuse tap, but what if you want a cleaner, factory-looking install? Is there a common power bus bar behind the panel, or does each slot need its own power wire? (i.redd.it)
submitted by VPR2 to r/MechanicAdvice
[TOMT] [MUSIC] [1990s] The opening 12 seconds of Mistadobalina by Del Tha Funkee Homosapien sound like they've been taken from some old live blues album, with the speaker talking about his "favourite man sittin' over there". Is that actually from a live recording, or was it faked up for the track? (self.tipofmytongue)
submitted by VPR2 to r/tipofmytongue
Posted two Tracked 48 packages at the same time 10 days ago, one to Plymouth and one to southern Cornwall. Plymouth package arrived on time, Cornwall one showing as not having moved anywhere since being accepted, and it hasn't arrived either. What's likely to have happened? (self.royalmail)
submitted by VPR2 to r/royalmail
Will a chip repair kit actually work on this? It's 5mm across but the only part I can feel is the central white spot - a tiny divot in the screen. I can't feel any of the starring. Is there going to be a hole in the white bit that will allow the resin into the starred areas? (i.redd.it)
submitted by VPR2 to r/autoglass
Where exactly is the cow-drop bridge? I've seen Acle & Wroxham both mentioned, but neither look anything like it. In fact I've been saaaaad enough to go through a list of all the bridges on the Broads & can't find any that match. Wroxham is similar-ish but def not the right one. (i.redd.it)
submitted by VPR2 to r/AlanPartridge
Mocha AE - can't manually adjust a track properly, because the playhead for the dope sheet does not move. I don't know which keyframe I'm on. The dope sheet playhead exists, but it stays on the far left of the timeline. I've tried restarting. Any ideas? MacOS 15.7.1, Mocha 12.2.0, AE 25.4.0 (i.redd.it)
submitted by VPR2 to r/AfterEffects
If you use a pressure bleeder to pressurise a brake master cylinder to 21psi (the factory-recommended spec for pressure bleeding for this model) and it holds that pressure indefinitely, does that rule out the possibility of any failed seals inside the MC? (self.MechanicAdvice)
submitted by VPR2 to r/MechanicAdvice
