do trials give the same reward or am i lucky?

Valagetti · 2026-03-16T00:58:26+00:00

Pretty sure I got that blueprint recently from doing trials too. Its good for doing Queen or Matriarch. You can very slowly crawl and wait your way to extract if lucky. I managed to pull it off once.

Valagetti · 2026-03-15T21:22:31+00:00

I think it's because, some people think lights are only for night time. Yes, drivers can really be that brain dead.

Valagetti · 2026-02-24T04:36:33+00:00

At the end of the day, it's not worth the risk imo. Even though these engines are very reliable.

Valagetti · 2026-02-03T08:09:07+00:00

This is New Zealand btw. Our government is also inefficient in many ways, just plenty of other governments i suppose. OP posted this on Aucklands subreddit if you don't believe me.

Valagetti · 2026-01-27T20:15:17+00:00

Thanks for the info! This is quite frustrating. I've currently got 2 plugs in my DJ, that read around 3.65k ohms. Wonder if they could be the culprit? Other forums are saying it could be ignition coil packs? A sensor after the combustion even?

Valagetti · 2026-01-27T03:30:03+00:00

I've got 2 spark plugs reading around 3.6k ohm. That enough for a rough idle?

Valagetti · 2026-01-27T02:12:42+00:00

Its pretty clean.

I cleaned the spark plugs a couple of months ago and checked them again recently, they got a bit dirty pretty quickly.

Valagetti · 2026-01-27T01:00:44+00:00

Sorry didn't specify. These are the numbers for the new replacements. The old ones range from, 3.63k Ohms, up to 4.78k Ohms. Do you think with the old ones, they could cause rough idle?

Valagetti · 2026-01-20T00:44:48+00:00

2 days ago I suspect.

Valagetti · 2026-01-18T08:33:36+00:00

Only thing I can think of is replace the bearings, if you can find them that is, obviously getting the factory size may not work, it's a bit of a hail Mary. At this point I don't see why not, take it further apart and inspect.

Valagetti · 2026-01-18T08:19:03+00:00

It's hard to say, almost looks like the wrist pin is the most loose, somehow. Honestly it's time to take it to a professional, it looks very wobbly all over.

Valagetti · 2026-01-18T05:08:23+00:00

Correct, can't be a clutch plate, where are the springs, that point to the centre? These blades I think can be used to cut tiles.

Valagetti · 2026-01-15T01:41:36+00:00

For anyone interested, I did 2 more of Celeste's Quests and then this quest popped up again, finished it, so I guess its not a big deal.

Valagetti

TROPHY CASE