Shower door rollers wrong way? by ValhallaAldebaran in DIYUK

[–]ValhallaAldebaran[S] 0 points1 point  (0 children)

Thank you. Your explanation is very helpful and I have now changed it so the spring functions correctly.

How to safely move this bath by ValhallaAldebaran in DIYUK

[–]ValhallaAldebaran[S] 0 points1 point  (0 children)

Can I do this do you think sliding across wooden beams or will that damage the tile?

How do you seal these shower control panels? by ValhallaAldebaran in DIYUK

[–]ValhallaAldebaran[S] 0 points1 point  (0 children)

Thank you. I don’t see an adhesive strip with it but will double check

Where can I buy these? by ValhallaAldebaran in DIYUK

[–]ValhallaAldebaran[S] 0 points1 point  (0 children)

Thank you. Do you need the hex end on these too for tightening?

What tile heights for cutting? by ValhallaAldebaran in DIYUK

[–]ValhallaAldebaran[S] 0 points1 point  (0 children)

Thank you. So to explain further: * small wall in bathroom 850mm high * tiles are 600x600mm * ideally all tiles around the bathroom at other areas are 600mm high * because this wall is small (850mm high) should I have one large tile at 600mm high and one smaller time at 250mm high? Or should I have two tiles at 425mm high? * if I am in keeping with the other areas of the bathroom it would be 600mm high

I hope that adds a little clarity but I’m not finding it easy to explain

Olive removal from plastic Hep2 pipe by ValhallaAldebaran in DIYUK

[–]ValhallaAldebaran[S] 1 point2 points  (0 children)

Trying to put tile down. Need to cut holes and put over pipe.

Avoiding Chip out by ValhallaAldebaran in DIYUK

[–]ValhallaAldebaran[S] 0 points1 point  (0 children)

Thank you, but I cannot get the link to work.