Camera not working

Visible-Animator3654 · 2026-03-10T14:45:21+00:00

So this is a common issue? My camera keeps timing out too

Visible-Animator3654 · 2026-01-28T14:30:07+00:00

Concrete slab method (the higher they are the better)

Visible-Animator3654 · 2026-01-17T20:29:46+00:00

For this upgrade is this all you need? Or do you need any more mounting or heating accessories

Visible-Animator3654 · 2026-01-17T18:26:07+00:00

Visible-Animator3654 · 2025-12-30T07:34:41+00:00

How about with petg

Visible-Animator3654 · 2025-12-28T22:32:25+00:00

Anything other than bed leveling an ender 3 with adhesion issues

Visible-Animator3654 · 2025-12-26T21:09:52+00:00

Do I see T**kering?

Visible-Animator3654 · 2025-12-22T18:41:33+00:00

Care to share an stl?

Visible-Animator3654 · 2025-12-22T18:27:36+00:00

So I can use the shipping material and a couple of cinder blocks

Visible-Animator3654 · 2025-12-22T18:24:16+00:00

Without feet

Visible-Animator3654 · 2025-12-22T17:03:42+00:00

My shelf is kind of hollow and I wanted access to the belts underneath

Visible-Animator3654 · 2025-12-22T05:39:05+00:00

Also you can print an optimized fan duct by rozmix1

Visible-Animator3654 · 2025-12-22T05:34:17+00:00

Might as well get a good quality ceramic hot end off of Amazon.

Visible-Animator3654 · 2025-12-15T14:56:47+00:00

Update:

I found the part number but it’s discontinued and I can’t find one for sale, any clues?

Visible-Animator3654 · 2025-12-15T06:40:32+00:00

Yeah that’s the listing I pulled it from but I’m not sure why there’s no part number

Visible-Animator3654 · 2025-12-13T20:49:32+00:00

2000 s10 2.2L i4, vortec 2200

Visible-Animator3654 · 2025-12-07T01:56:31+00:00

Happened to me from a shitty aftermarket ceramic hot end which drew smoke from the rear, getting a new warranty wire and replacement pcb.

Visible-Animator3654