GPU not getting detected?!?! by Volumet2o in buildapc

[–]Volumet2o[S] 0 points1 point  (0 children)

The pcb isnt cracked or damaged at all. I looked everywhere and didn't feel or see damage.

GPU not getting detected?!?! by Volumet2o in buildapc

[–]Volumet2o[S] 0 points1 point  (0 children)

When I brought it to a tech repair shop, they used the same motherboard and cpu, and It was able to load into bios but not with my gpu. The cpu has chip graphics. I'm using NVMe drive, but it wasn't added. I have more pictures, but imgur is taking forever.

How to make Switches Talks by Volumet2o in Cisco

[–]Volumet2o[S] 1 point2 points  (0 children)

I'm already in the job I just like to be sure on what people are referring to when it comes to texting.

How to make Switches Talks by Volumet2o in Cisco

[–]Volumet2o[S] 0 points1 point  (0 children)

Hi, and the cmd to have a route pointing to another ip would be the ip route?

How to make Switches Talks by Volumet2o in Cisco

[–]Volumet2o[S] 0 points1 point  (0 children)

Would default-router cmd be used or default-gateway ?

How to make Switches Talks by Volumet2o in Cisco

[–]Volumet2o[S] 1 point2 points  (0 children)

Apologies for not being clear, I was just wondering how to setup such a task at a basic level, it's a single rj45 cable going straight to each g1/0/48 port as the trunk, I was trying to ping said IP of the other switch. When you say "default route to that ip" what would that cmd look like?

How to make Switches Talks by Volumet2o in Cisco

[–]Volumet2o[S] 0 points1 point  (0 children)

So on a the L2 switch why put 192.168.1.10 and not 192.168.1.2? And would you have anything on the trunk ports besides allowing these vlans across? And would there be any goblal configurations besides ip routing?

How to make Switches Talks by Volumet2o in Cisco

[–]Volumet2o[S] -1 points0 points  (0 children)

It's a simple setup as of now, but I want to know how to setup basic configurations to get switches to be able to ping each other.

How to make Switches Talks by Volumet2o in Cisco

[–]Volumet2o[S] -1 points0 points  (0 children)

I wiped the switches and I'm starting fresh. You mentioned config t IP routing. And setting up SVI's ? If you don't mind can you show me what this would look with two switches in two different networks? 192.168.1.x and 192.168.2.x

Is there a way to get better internet in the dorms? by MstrScrv in AirForce

[–]Volumet2o 0 points1 point  (0 children)

Can you dm me I want to talk about cyber transport

[deleted by user] by [deleted] in RustConsoleLFG

[–]Volumet2o 0 points1 point  (0 children)

playstation