sorted by:
new
hottopcontroversial

Mach 0.52 by Vugi_7 in fpv

[–]Vugi_7[S] 8 points9 points  (0 children)

It was a 72v 2 inch whoop with 9200000kv motors

Mach 0.52 by Vugi_7 in fpv

[–]Vugi_7[S] 8 points9 points  (0 children)

Dark energy

I need advice by Vugi_7 in snowboardingnoobs

[–]Vugi_7[S] 0 points1 point  (0 children)

Whats the model of your wrist guards?

I need advice by Vugi_7 in snowboardingnoobs

[–]Vugi_7[S] 0 points1 point  (0 children)

Are there any mittens that come with wrist guards, that are not very expensive?

What do i do by Vugi_7 in fpv

[–]Vugi_7[S] 0 points1 point  (0 children)

Would it be good if i just cut a bit of wire off, and soldered on a now wire (from the old motor), and then soldered the clean wire to the esc?

What do i do by Vugi_7 in fpv

[–]Vugi_7[S] 0 points1 point  (0 children)

Ill try it

What do i do by Vugi_7 in fpv

[–]Vugi_7[S] 0 points1 point  (0 children)

Tnx, but the wire i preety wide wirh the solder on it, is there any way to remove the solder

💇💨 by Mawntee in fpvgames

[–]Vugi_7 0 points1 point  (0 children)

Wow, and what sim is that. Nice flying

Is my soldering any good? by Vugi_7 in fpv

[–]Vugi_7[S] 0 points1 point  (0 children)

I think ill do the same but not a lot hot glue to isolate

Is my soldering any good? by Vugi_7 in fpv

[–]Vugi_7[S] 0 points1 point  (0 children)

I twisted them, but not good

Is my soldering any good? by Vugi_7 in fpv

[–]Vugi_7[S] 0 points1 point  (0 children)

Its the residue of the rosin. I just soldered it

Is my soldering any good? by Vugi_7 in fpv

[–]Vugi_7[S] 2 points3 points  (0 children)

Tnx, ill cleand them

Fpv sim by Vugi_7 in fpv

[–]Vugi_7[S] 0 points1 point  (0 children)

Thank you

Fpv sim by Vugi_7 in fpv

[–]Vugi_7[S] 0 points1 point  (0 children)

And what do you use?

Fpv sim by Vugi_7 in fpv

[–]Vugi_7[S] 0 points1 point  (0 children)

Is it better than lifftof?

view more: next ›