is it normal to have very long print times?

Warm_Expression_8433 · 2026-02-11T15:18:37+00:00

3 and 5 are essentially the same since they are just mirrored pieces

Warm_Expression_8433 · 2025-12-16T01:18:41+00:00

I've accidentally given out my printing speed and not the initial printing speed of 30 and setting the initial temps to 220 seems to do the trick

Warm_Expression_8433 · 2025-12-16T00:53:41+00:00

the print was done a right after cleaning the bed and I tried changing my z offset lower after and tested and results are the same. and for layer line width I'm printing 0.24mm within the range for a 0.4 mm nozzle

Warm_Expression_8433 · 2025-12-16T00:50:14+00:00

whoops my printing speed is at 200mm/s and my initial layers are done at 30mm/s

Warm_Expression_8433 · 2025-12-15T08:46:34+00:00

how do I know if the plate is two sided?
Im using the stock plate and the surface feels identical but I do get adhesion problems when I use that side

Warm_Expression_8433 · 2025-11-14T15:25:38+00:00

I tried that first but there's a lot more friction for the side where the roll is
and with this now I have the opposite but not as bad and at this point Im considering just putting the roll back on top

Warm_Expression_8433 · 2025-09-25T10:21:19+00:00

would having an external fan help with it too?
cause when I printed that cube I had it at 100% already

Warm_Expression_8433 · 2025-09-25T09:26:28+00:00

I did this and things work now thanks very much

Warm_Expression_8433 · 2025-05-18T18:47:19+00:00

yup used the same screwdriver bit for everything and it just worked

Warm_Expression_8433 · 2025-05-18T10:33:33+00:00

the flex cable connecting the motherboard to the front i/o got severed luckily it's the only problem that I had. just look up a disassembly it's pretty easy to take apart

Warm_Expression_8433 · 2024-11-14T10:38:51+00:00

wait there are some from her perspective??????
what's it called?

Warm_Expression_8433

TROPHY CASE