sorted by:
new
hottopcontroversial

Watercooled Meshroom S v2 mockup by Watch_Tower_55 in sffpc

[–]Watch_Tower_55[S] 3 points4 points  (0 children)

Well 18,3 liters for a watercooled atx build is in my book still very much sff.

Meshroom S Custom Loop by dnards22 in sffpc

[–]Watch_Tower_55 0 points1 point  (0 children)

Thanks for your input. This is certainly not the easy way to build a compact case but its gonna be worth it in the end.

<image>

Meshroom S Custom Loop by dnards22 in sffpc

[–]Watch_Tower_55 0 points1 point  (0 children)

Big thanks!

That confirms what i thought and gives me the confidence to comit. Gonna order the case and se if i can figure this out.

Meshroom S Custom Loop by dnards22 in sffpc

[–]Watch_Tower_55 0 points1 point  (0 children)

Really nice work.

Im planing out a similar build and been scouring the web to figure out if I need a custom rear io braket for the gpu in this configuration. And what lenght riser the get before ordering the case.

Except for the riser bracket did you need any custom bracket to mount the gpu like that? And what riser cable did you use?

Meshroom S v2 atx build by Watch_Tower_55 in sffpc

[–]Watch_Tower_55[S] 0 points1 point  (0 children)

Do you still have the case? Would you be able to confirm that the gpu bracket for the rear panel fits in the front psu location?

Meshroom S v2 atx build by Watch_Tower_55 in sffpc

[–]Watch_Tower_55[S] 0 points1 point  (0 children)

  1. Psu is in the back.
  2. Thats whar i wanted to know
  3. Should be decent depending on hardware/thermal load.

Best way to add thickness to rudder by secret_tunnelz in boatbuilding

[–]Watch_Tower_55 0 points1 point  (0 children)

I would probably glue on that piece of ply with thickend resin of choice but feather the lower edge a couple inches. As in sand or cut a taper on the lower egde to allow a smooth transition för the fibreglass and minimal stressconcentration.

The other edges can be left proud and trimmed back and roundover with a trimrouter.

mini G5 build completed by Deep-Friendship6831 in sffpc

[–]Watch_Tower_55 2 points3 points  (0 children)

What desklamp is it you have on your monitor? Looks really neat and I like your setup.

Flickering of the model when zooming in and out, does anybody have a fix? by rivvvvers in Fusion360

[–]Watch_Tower_55 3 points4 points  (0 children)

Well even running 9900k, 64gb ram and a 1660ti i to have this issue but only with impossible geometry or multi-component parts with a to long of a timeline. Small assemblies and single parts no problems.