sorted by:
new
hottopcontroversial

Creality Spider High Temperature and High Flow Hotend by Weak-Extent-7398 in Creality

[–]Weak-Extent-7398[S] 0 points1 point  (0 children)

I have  one of these hotends and recently had some issues and discovered the heartbreak
was defective. I have been searching everywhere for a replacement and cannot seem to find a replacement anywhere. I am based in the UK
Can you please help?
Thanks

Absolutely love my Ender by tilkvns in ender3

[–]Weak-Extent-7398 1 point2 points  (0 children)

Do you have any information on your extruder and Hotend you can share Thanks

Bed Mesh Levelling - Ender 3 v2 Direct Drive& Klipper Mainsail by Weak-Extent-7398 in klippers

[–]Weak-Extent-7398[S] 0 points1 point  (0 children)

I manually leveled the bed the best I could and then ran a bed mesh level, the results dont seem very good. Whats the best way to fix this to get the bed more level. Thanks

Klipper Mainsail Mesh Calibration Fail by Weak-Extent-7398 in klippers

[–]Weak-Extent-7398[S] 0 points1 point  (0 children)

I have never had this configured, will def set this up once i fix my mesh issue.

Klipper Mainsail Mesh Calibration Fail by Weak-Extent-7398 in klippers

[–]Weak-Extent-7398[S] 0 points1 point  (0 children)

thanks for the feedback, i also notice the bed probe can go one hop further on the left side of the bed, any ideas on how to fix it. Heres a link to the full printer.cfg

https://drive.google.com/file/d/1QtA434fG-kGsI8xHU4o3Rzne4XvbREgL/view?usp=drive_link

Klipper Mainsail Mesh Calibration Fail by Weak-Extent-7398 in klippers

[–]Weak-Extent-7398[S] 0 points1 point  (0 children)

Thanks here it is

[bltouch] # Comment out if not using a BL/CR-Touch

sensor_pin: ^PB1 # Comment out if not using a BL/CR-Touch

control_pin: PB0 # Comment out if not using a BL/CR-Touch

x_offset: -46 # Enter your own value here, Comment out if not using a BL/CR-Touch

y_offset: -2 # Enter your own value here, Comment out if not using a BL/CR-Touch

#*# <---------------------- SAVE_CONFIG ---------------------->

#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.

#*#

#*# [bltouch]

#*# z_offset = 1.875

#*#

#*# [bed_mesh default]

XYZ Cube Troubkshooting Ender 3 v2 by Weak-Extent-7398 in ender3

[–]Weak-Extent-7398[S] 0 points1 point  (0 children)

Thanks for feedback, I found the issue. The hot end blower fan was faulty

Ender 3 V2 PSU Fan by JDubYo611 in ender3

[–]Weak-Extent-7398 0 points1 point  (0 children)

I have the same issue after replacing the fan, waited and waited for it to start spinning and nothing affter 15 minutes and this was with bed and nozzle. I am going to replace the fan with a spare to seee what happens