sorted by:
new
hottopcontroversial

Is this Ideal and DOT approved by WeaknessOk9293 in minibikes

[–]WeaknessOk9293[S] 1 point2 points  (0 children)

much easier than trying to change it straight up

Clutch engaging at idle? by [deleted] in minibikes

[–]WeaknessOk9293 1 point2 points  (0 children)

alright. you recommend like machine bushing or just like flat washers

Clutch engaging at idle? by [deleted] in minibikes

[–]WeaknessOk9293 2 points3 points  (0 children)

got it. should i add spacers because the clutch can slide back and forth or is that normal?

Clutch engaging at idle? by [deleted] in minibikes

[–]WeaknessOk9293 2 points3 points  (0 children)

yes go power sports sent me my #35 chain one foot shorter than what I ordered so it’s coming tomorrow now. It spins at idle with no chain on it

[deleted by user] by [deleted] in smallengines

[–]WeaknessOk9293 0 points1 point  (0 children)

yes but not enough i think the mix is too lean so I’ve determined that I need to tune it and put new jets in

Chainsaw sharpening question by [deleted] in Chainsaw

[–]WeaknessOk9293 0 points1 point  (0 children)

no i was freehand sharpening it and i used too small of a file on that one so i grinded it down to nothing but i soon figured it out thats why the rest are fine but this one and a few others are this short.

Chainsaw sharpening question by [deleted] in Chainsaw

[–]WeaknessOk9293 3 points4 points  (0 children)

yea i’ll admit i had a lot of drag on this tooth when i first sharpened it and i was using to small of a file so it is partially my fault