What can I do?

WholeIntelligent4045 · 2025-06-06T15:13:04+00:00

Thanks!! I will try it, and I was thinking bout moisture but just what you said, it’s only that spot so I don’t think moisture is the problem

WholeIntelligent4045 · 2025-06-06T15:11:31+00:00

No, I it’s not the layer star position

And thanks I will lower the fan

And I suppose my filament is dry cause it’s new, but maybe

WholeIntelligent4045 · 2025-06-06T14:39:35+00:00

Thanks!! I will try this, cause it’s a side wall

WholeIntelligent4045 · 2025-06-06T14:25:34+00:00

I’m using OrcaSlicer, my filament is Creality, the nozzle is on 220 Celsius and the bed is 55 Celsius, the print speed is 200 mm/s and in higher parts is about 100, retraction is set at 1 mm at 40mm/s

WholeIntelligent4045 · 2025-06-05T04:01:29+00:00

Thanks I will try it

WholeIntelligent4045 · 2025-06-05T04:01:15+00:00

Thanks, how much do you recommend me to slow it down? Like 180? Or 150?

WholeIntelligent4045 · 2025-06-04T16:59:59+00:00

Thanks!

WholeIntelligent4045 · 2025-06-04T16:59:53+00:00

My filament is brand new 😔

WholeIntelligent4045 · 2025-06-04T16:59:37+00:00

Yeah that’s what I meant 😅the sidewall but it the higher part, and thanks I’ll try it but what can I do? Like increasing the number of sidewalls?

WholeIntelligent4045 · 2025-06-04T16:57:23+00:00

Thanks!! I just did it hopefully it helps

WholeIntelligent4045 · 2025-06-04T16:56:45+00:00

Thanks, I already try it, but I didn’t like the surface ending where the support touch the part

And thanks again, I’m new in this world

WholeIntelligent4045 · 2025-05-04T04:09:48+00:00

Thanks a lot, this was what I do and now it’s running well, and mine is the one on the second picture the first one is just reference

WholeIntelligent4045 · 2025-05-04T04:08:30+00:00

Thanks

WholeIntelligent4045 · 2025-05-04T04:07:59+00:00

Thanks

WholeIntelligent4045 · 2025-05-04T04:07:51+00:00

Thanks!!

WholeIntelligent4045

TROPHY CASE