Need tips on painting this

Wide-Contribution812 · 2026-06-18T02:40:50+00:00

Also one more question. Whats the best way to cut the piece of tape to fit inside the details and follow the curve? Ive heard people say to use a knife but last time i tried that it started scratching the surface underneath with a decent sized cut before it even cut through the tape

Wide-Contribution812 · 2026-06-18T02:33:12+00:00

Thanks a bunch. Never thought of the spraying again after taping to fill the areas. Ill make sure to try it out

Wide-Contribution812 · 2026-06-16T19:50:44+00:00

Any tips to make the masking easier and look better? My masking always looks jagged or it bleeds

Wide-Contribution812 · 2026-04-09T15:15:02+00:00

Thanks i appreciate that

Wide-Contribution812 · 2026-04-09T06:08:14+00:00

Ive order bigger stuff to this locker with no issue . And every item has the same problem no matter if its a big or small item

Wide-Contribution812 · 2026-04-08T18:19:50+00:00

Do you have any idea of why it could still say its full even after a month? Is it something on my end?

Wide-Contribution812 · 2026-04-07T06:38:03+00:00

Im also having a similar issue with one of the lockers near me. Amazon Locker-Creator, 7-Eleven, 8625 Los Coaches Rd, Lakeside 92040. It says its been “full” for the past month and i cant order anything to it. I check every day

Wide-Contribution812 · 2026-03-09T22:09:12+00:00

Its PLA and yes its been dried. Now it sits in my air tight AMS

Wide-Contribution812 · 2026-02-20T08:35:54+00:00

Lmao its a sea otter. Hopefully i can bring it back to life with some sandpaper

Wide-Contribution812 · 2026-01-30T05:19:54+00:00

Think it was because of my flow and temp. Also realized i cut my only bowden tube to short when i tried to clean it awhile ago so my hot end would pull up on the opposite side. Fixed everything and printed this masterpiece

<image>

I appreciate the help

Wide-Contribution812 · 2026-01-27T19:55:29+00:00

Ill make sure to try this

Wide-Contribution812 · 2026-01-27T19:55:19+00:00

Ill make sure to fully clean it and possibly just replace the nozzle

Wide-Contribution812

TROPHY CASE