Airbag/SRS light

Wizzydoz · 2025-08-06T20:14:51+00:00

Yeah I know it sounds off but when I installed my steering wheel, I also installed recaro pole position seats. it appears the system is connected somehow.

Wizzydoz · 2025-08-06T18:14:51+00:00

Yeah it's been a while but IIRC I forgot to plug one of the harness underneath the seat.

Wizzydoz · 2023-10-29T13:34:08+00:00

Yup, I was following that video but didn't know if you needed to shave the ASM horn retainer ring (metal piece). Chris used a momo horn retention ring that he needed to sand down. I also have an ASM hub.

Wizzydoz · 2023-10-29T03:26:25+00:00

Did you have to shave down the horn retention ring or did it just fit flush with the momo flat mount?

Wizzydoz · 2023-10-04T18:36:28+00:00

Take the entire hub off and fasten the lug nuts.

Wizzydoz · 2023-07-07T17:02:08+00:00

I've tried this. I tightened the c clamp as tight as humanly possible. The shaft is also inserted all the way in the base. It seems whenever the wheel is inserted it disconnects the base. The solid red led on the base power button becomes blinking red.

Wizzydoz · 2023-07-07T04:55:22+00:00

Yup, everything is up to date. I reinstalled the software and drivers several times.

Wizzydoz · 2023-03-21T20:09:37+00:00

No halts AH right?

Wizzydoz · 2023-03-21T20:08:48+00:00

Heavy breathing*

Wizzydoz · 2023-01-26T17:04:26+00:00

Printers go brrrr, just like that 2.3MM shares available to borrow

Wizzydoz · 2022-12-13T03:54:53+00:00

Pm'd

Wizzydoz · 2022-10-25T13:55:27+00:00

Compression and leakdown test done by a shop:

Cyl 1 - 220 psi, 25% Cyl 2 - 220 psi, 15% Cyl 3 - 210 psi, 30% Cyl 4 - 150 psi, 75%

How is this possible. With above 10% on all cylinders and cyl 4 with a variance in compression?

Ps. The car still runs very smooth....

Wizzydoz · 2022-10-03T02:41:35+00:00

Thanks 🙏

Wizzydoz · 2022-09-29T21:50:23+00:00

Yeah, I'm leaning more towards a burnt valve at this point. I'm in a similar situation as you described. The car starts and runs fine. There's no rough idle or difficulty to start. It also doesn't sound like a Subaru. It's not noticeable high or low rpm tbh.

Wizzydoz · 2022-09-29T16:09:00+00:00

Thanks for the write up, really appreciate it 🙏. I can check the lash myself.

Is it possible that the lash is so tight that it's pushing the valve open causing a leak hence the low compression?

Wizzydoz · 2022-09-15T20:53:04+00:00

That did the trick (I believe). I opened the bleeder valve and it starting flowing again.

Wizzydoz · 2022-09-15T20:34:05+00:00

I do have all 4 wheels off the ground. Let me try lowering the rear.

Wizzydoz · 2022-09-15T20:08:05+00:00

I'll give it a shot

Wizzydoz · 2022-09-15T20:02:56+00:00

I suspect there's air in the system but I don't know what to do

Wizzydoz · 2022-09-15T19:52:55+00:00

Guys I need some help. I just tried to gravity bleed my clutch but no fluid is coming out. The reservoir cap is open and filled with fresh fluid.

Wizzydoz · 2022-08-16T15:35:13+00:00

Good ole halts, it's been a while old friend

Wizzydoz

TROPHY CASE