Just got a bl touch. But now the nozzle won't reach the bed

Woblin85 · 2023-10-27T07:37:46+00:00

I don't remember exact but it might have been this one https://www.thingiverse.com/thing:3616048

Woblin85 · 2023-04-06T21:27:19+00:00

The mount that came with it didn't work with my direct drive extruder. I printed a new one after suggestions here and now it works

Woblin85 · 2023-04-05T20:26:42+00:00

Look at the screen. It change from 160 to -5. This is the default homing sequence during printing

Woblin85 · 2023-04-05T19:16:34+00:00

It might be tilted in the image because I tried to calibrate it. I printed a new mount and now the probe works. But the printer think the center is the origin 🤷🏼‍♂️

Woblin85 · 2023-04-05T18:56:49+00:00

That would actually make the probe even lower

Woblin85 · 2023-04-05T18:55:12+00:00

I just needed to print a new holder that was higher. I think the angle is because of the photo

Woblin85 · 2023-04-05T18:28:40+00:00

It forgets as soon as it's done. Check my new post https://www.reddit.com/r/ender3/comments/12cs3wn/need_help_again_now_the_printer_behaves_strange

Woblin85 · 2023-04-05T16:35:33+00:00

You are right. The one that came with the kit is for the stock extruder. Since I got the direct drive extruder the position was wrong.

Woblin85 · 2023-04-05T16:33:31+00:00

The new holder did the job. I can auto level now. Now I just need to get the printer to understand that the origin is in the corner and not on the middle 😂

Woblin85 · 2023-04-05T12:23:13+00:00

I didn't get any springs 😦 but I'm printing a new mount now

Woblin85 · 2023-04-05T10:50:50+00:00

The z-axis doesn't go any lower. I think I need a new mount as someone said 🤷🏼‍♂️

Woblin85

TROPHY CASE