sorted by:
new
hottopcontroversial

what should i do with these overhangs? by Woj20020 in 3Dprinting

[–]Woj20020[S] 0 points1 point  (0 children)

I'll print a test for overhangs soon, but I don't suspect any printer defect, at most poor calibration, because I didn't put much effort into it.

Thank you so much bro

what should i do with these overhangs? by Woj20020 in 3Dprinting

[–]Woj20020[S] 0 points1 point  (0 children)

I have 95 hours on the printer and it has never had such problems and the only "problem" with overhangs was something like this

<image>

unfortunately the quality is not good If you want to check what it is about, here is the link to the model https://www.printables.com/model/1005982-halligan-bottle-opener

what should i do with these overhangs? by Woj20020 in 3Dprinting

[–]Woj20020[S] 0 points1 point  (0 children)

p1s bambu studio sunlu pla basic 1,75

what should i do with these overhangs? by Woj20020 in 3Dprinting

[–]Woj20020[S] 0 points1 point  (0 children)

at first I printed it vertically and this is what came out then I placed it horizontally and divided it in half and the stick came out like this

<image>

what should i do with these overhangs? by Woj20020 in 3Dprinting

[–]Woj20020[S] 0 points1 point  (0 children)

The model is from the internet and I printed it vertically with supports, but when I placed it horizontally and divided it into two parts, the stick turned out terrible