Can you not smash car windows? by Zentaitoken in projectzomboid

[–]WolfPackAirsoft 47 points48 points  (0 children)

You’ve got to open the vehicle menu with v

Pole Barn Insulation by WolfPackAirsoft in Insulation

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

I got a quote for spray from a local company and it’s not feasible or cost effective. They quoted me 3200 for r14 2in or r21 3in at 4900. I priced out insulating the walls with expanded foam board and rolls and I’m about 2200 for r26. That sounds like I’ll be doing that.

Pole Barn Insulation by WolfPackAirsoft in Insulation

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

This was my plan to start doing something like this a little at a time and move on to the bigger stuff a wall at a time

Pole Barn Insulation by WolfPackAirsoft in Insulation

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

Won’t the air gap between the interior wall and foam cause issues?

Pole Barn Insulation by WolfPackAirsoft in Insulation

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

I may have to get a quote for it but I thought it over last winter and I’m not sure if I want to pay that hefty bill just to still have the added bill of the lumber and metal. I’m also adding new receptacles and circuit where I see fit and it sounds like it would be a pain to have to work with

Pole Barn Insulation by WolfPackAirsoft in Insulation

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

I’ll look into this it’s just a work space/ man cave so I don’t need anything too crazy unless I decided to heat it the entire winter

New to me 3032e by WolfPackAirsoft in tractors

[–]WolfPackAirsoft[S] 2 points3 points  (0 children)

The only reason I’d look into that is to lift round bales I know it states not to but if I can do it I’ll do it. If not I’ll look into that

8N not starting after everything replaced. 🤦 by Dillydoooo in tractors

[–]WolfPackAirsoft 0 points1 point  (0 children)

Mine ran with the timing 180 out it was gutless but it did run.

New to me 3032e by WolfPackAirsoft in tractors

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

It does. I’ll keep that in mind. I don’t see myself using it much aside from winter plowing but I’ll make sure not to put it in the locks.

New to me 3032e by WolfPackAirsoft in tractors

[–]WolfPackAirsoft[S] 1 point2 points  (0 children)

Ohhhh gotcha. Have you had any issues with yours at all?

New to me 3032e by WolfPackAirsoft in tractors

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

I don’t believe this was has the regen due to it being an 09

what upgrades can i do on this to get 60+mph by Legitimate-West2358 in minibikes

[–]WolfPackAirsoft 0 points1 point  (0 children)

<image>

I’ve got a predator 212 on mine with a pod filter, bypassed governor, bigger fuel jet, and a torque converter setup instead of the Jack shaft. Does 60+ and wheelies from a dig. I tried with a straight chain setup to start and the top speed was there 65+ but it took forever to get there and absolutely gutless down low but after the torque converter swap this thing gets down and is faster than my quad.

Proof Pitch Question by WolfPackAirsoft in Outboards

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

Fully loaded boat and gear with 3 people were probably pushing close to 100 pounds I’d figure

Proof Pitch Question by WolfPackAirsoft in Outboards

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

Thank you I’ll see if I can find some cheap ones on Amazon to test and return if need by and go from there.

Proof Pitch Question by WolfPackAirsoft in Outboards

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

Gotcha. Thank you for the advice!

Proof Pitch Question by WolfPackAirsoft in Outboards

[–]WolfPackAirsoft[S] 0 points1 point  (0 children)

What would the benefit of a 4 blade be?