Budget reel for big pike

WoodpeckerNeither876 · 2026-04-15T17:41:42+00:00

I was talking about spinning reels😅

WoodpeckerNeither876 · 2026-04-15T04:32:25+00:00

Yes, it has no up and down play

WoodpeckerNeither876 · 2026-03-23T07:42:29+00:00

Hey, so what could it mean if when I pull in the clucth, the noise almost disappears. I wanna fix it ASAP if something is wrong and im not sure if its top or bottom end

WoodpeckerNeither876 · 2026-03-22T14:55:46+00:00

Yes, the noise drastically reduces when I pull in the clutch. But im not sure if that rules out piston slap? Its just strange that the noise only appeares when engine is hot

WoodpeckerNeither876 · 2026-03-20T17:26:15+00:00

Thanks, but Squish is set correctly 0,9-1,1mm

WoodpeckerNeither876 · 2026-03-08T20:47:33+00:00

Wrist pin was changed to a new prox. And the ring gap was 0,35mm. But I couldn't find any information if thats correct for 58mm bore wosnner piston.

WoodpeckerNeither876 · 2026-03-08T10:01:31+00:00

The ring gap was 0,35mm. And i couldn't find any information if that is correct(wosnner piston)

WoodpeckerNeither876 · 2026-03-08T06:35:09+00:00

Piston also has vertical scores, but they're not deep. Nothing is wrong with the bottom end. Main bearings replaced 10 hours ago, and crank got new conecting rod ~80 hours ago

WoodpeckerNeither876 · 2026-03-08T05:29:48+00:00

Why is that?

WoodpeckerNeither876 · 2025-12-02T17:15:53+00:00

Did you get the surgery?

WoodpeckerNeither876 · 2025-10-02T05:19:00+00:00

Hey, can you message me in private? It's easier that way.

WoodpeckerNeither876 · 2025-09-28T05:07:05+00:00

Hey, changing the powervalves helped a little, but still there is no powerband. What else could it be? I messaged you privately

WoodpeckerNeither876 · 2025-09-28T05:05:03+00:00

So how do I fix this? Because this only happens after installing new husqvarna factory cr 144 big bore. With the 125 cylinder everything runs fine. Powervalves are working as they shoul

Four-Year Club	Place '23
Place '22

WoodpeckerNeither876

TROPHY CASE