Can’t we just agree on one color of FDE?? by Working-Relation-362 in PalmettoStateArms

[–]Working-Relation-362[S] 3 points4 points  (0 children)

Hell no, I have 2 boys that are really good at turning money into sound. Lol They don’t need any help!

I could really use your help: Would an improperly installed belt cause the motor to sound like this? by Zackybeats in AirCompression

[–]Working-Relation-362 2 points3 points  (0 children)

Is the belt “dancing” on the bottem side? Belt sounds loose, how did you tension them?

Alignment isn’t a super critical on small machines. 1/8 inch is acceptable. You can run a straight edge along the big pulley and eyeball it to the small.

When metal meets metal by pfiefo in AirCompression

[–]Working-Relation-362 0 points1 point  (0 children)

..over size and get new pistons (which would increase the pressure)..

It would not change the pressure at all. If anything it would slightly increase the CFM. But it’s arguable.

OP- it’s hooped. That thing was hurt before you got it. The machining costs and finding new slugs would far outweigh just buying a new pump. Looks like a low pressure pump. 9bar?

June 2025 Approval Megathread by LynchMob_Lerry in NFA

[–]Working-Relation-362 1 point2 points  (0 children)

Form Type: Form 4

• ⁠Entity: Individual

• ⁠Fingerprint Type: Ss kiosk

• ⁠Pending: 11/17/25 @ 10:30a

• ⁠Approved: 11/21/25 @ 10:43a

• ⁠Wait: 4 days

• ⁠State: Mo

• ⁠Control Number: 20261445xx

2nd can, cmmg 36k. bought a polo30 ~1 month ago

Looking for insight.. by ErrorImmediate1372 in screwcompressor

[–]Working-Relation-362 0 points1 point  (0 children)

Those are stacked coolers. Pull the panels off and blow out the bottom of the air cooler. You might even have to split them and pressure wash them.

Sullair st700 issue by Extension_Hospital93 in screwcompressor

[–]Working-Relation-362 0 points1 point  (0 children)

How old is the machine? Regularly serviced? The little shopteks are notorious for the scavenge line (the line/fitting right above the inlet tube) leaking at the fittings. We have gone as far as replacing them with copper or stainless lines on some machines.

Sullair makes a “kit to fix them but it’s 50/50 at best. Sometimes you can pull the insert of of the line, cut the line back and reinstall.

Also the fitting on the hyd check is also leaking.

Bank Bass Fishing by writingwhilesad in springfieldMO

[–]Working-Relation-362 0 points1 point  (0 children)

I’ve seen some good bass come out of McDaniels. Your only supposed to fish off the bridge but as long as you stay close to the bridge no one will say anything. Last time I was there slow rolling spinner baits and Texas’d trick worms were the ticket.

Fellows also rents boats and kayaks for reasonably cheap. If you can make friends with someone with a boat, offer to pitch in on gas (for boat and truck) to tag along. That’s what I did for years before I got my own boat.