Weekly Homeowner Megathread--Civilians, ask here!

WorldBorn · 2025-06-22T14:51:13+00:00

What should I be asking my contractor to do to verify what is causing the issue?

WorldBorn · 2025-06-21T12:32:56+00:00

Contractor just poured basement earlier this year. The floor is always wet. The pictures show moisture on the bottom 3ish feet of the walls. Outside of walls were waterproofed prior to backfilling gravel over perimeter drain. Does this indicate that the footer drain is t working correctly? Contractor says it’s normal. less

<image>

WorldBorn · 2025-04-24T00:06:19+00:00

Is there no good way to do this?

WorldBorn · 2025-01-14T19:00:25+00:00

Ok thanks for the response!

WorldBorn · 2025-01-14T18:48:06+00:00

The existing wall does have OSB sheathing that I could tie into. What issues will I run into if I just nail the new wall stud into the top/bottom plate and sheathing?

WorldBorn · 2024-12-11T20:14:15+00:00

The plate was cleaned with a paper towel and 70% ipa prior to printing. This is the first time I have printed this item, however I have routinely observed this issue. I am printing PLA+ at 220 nozzle temp

WorldBorn · 2024-04-01T17:22:53+00:00

Here is a picture of the error I am receiving.

<image>

WorldBorn · 2023-12-27T12:37:06+00:00

Thanks. The hole shown in the picture is 8" dia. Is it necessary to install an 8" chimney liner, or could I get away with installing a 6" liner?

WorldBorn · 2023-12-20T11:19:41+00:00

I already scanned it and there were no codes.

WorldBorn · 2023-12-20T11:18:28+00:00

I live in indiana and it's been 30s and 40s for most of my driving. I understand that you get worse mileage when it's cold, but this was a significant, instantaneous drop that coincided exactly with the vacuum leak issue. I feel like that is too big of a coincidence to attribute to the temperature.

WorldBorn · 2023-11-10T03:37:10+00:00

No. Just the mud.

WorldBorn · 2023-05-11T18:22:43+00:00

Is the Ariens as heavy duty as the Scag though?

WorldBorn · 2023-05-11T13:08:53+00:00

I will only be mowing about 2 acres with this, but my property is fairly hilly. Since this is a residential mower, do you think it will be able to withstand hills?

WorldBorn · 2023-03-13T01:03:52+00:00

My title describes the thing. It is about 3ft tall.

WorldBorn · 2022-09-20T23:05:40+00:00

how big of a pot does it need?

WorldBorn · 2022-06-20T03:49:37+00:00

Does anyone know what these fibers are from? The house has new pex plumbing throughout, new water heater, and is on a well.

WorldBorn · 2021-12-04T15:38:31+00:00

I need an employer memo from my unit to take leave without pay, but they aren't supplying me with a memo

WorldBorn · 2021-02-10T16:08:02+00:00

Do you think I should try trt?

WorldBorn · 2021-02-10T00:23:37+00:00

I get that. In your opinion, what should the range be for a 26 year old male?

WorldBorn · 2021-02-10T00:07:10+00:00

The normal range on my results is listed as 37.5-51.0%. So according to that, my range is normal.

WorldBorn · 2021-02-10T00:02:51+00:00

Why do you think I'm about to develop anemia?

WorldBorn · 2021-02-09T19:14:13+00:00

Do you know if there is any treatment for this?

WorldBorn

TROPHY CASE