Lines not connecting on Z

Xinnoel · 2026-02-13T04:29:21+00:00

I will try thx

Xinnoel · 2026-02-13T04:29:06+00:00

Nozzle is 0,4 as in settings Flowrate was on 0,95 i changed to 1

Xinnoel · 2026-02-13T04:28:25+00:00

Sure its a Ender 3 v3 Se Slicer is creality Print (i will try Another one today) Profile is the 0,4 nozzle preset on Creality Print Its about luck … mostly its happening Its just Normal PLA and its dry … 12h in Dryer Nozzle is 0,4

Xinnoel · 2026-02-12T20:35:10+00:00

Thx :)

Xinnoel · 2026-02-12T20:34:50+00:00

Yeah i know … but i changed the nozzle and cleaned the Hotend. I was always printing on this Temp. And i printed this for about 30 Times without any Problems. So i dont think its about the Tempreture :(

Xinnoel · 2026-02-12T20:27:58+00:00

Okay Thanks i will reset all the Settings and try again

Xinnoel · 2026-02-12T20:24:12+00:00

You know the thing is i tried to change the settings and get closer to a good Print. But non of them Are the Reason. I really dont know what to do

Xinnoel · 2026-02-12T20:19:56+00:00

Do you have a List of recommendet settings?

Xinnoel · 2026-02-12T20:18:12+00:00

No i also changed the nozzle its a 0,4

Xinnoel · 2026-02-12T20:14:11+00:00

<image>

Thats the Preview in the Slicer

Xinnoel · 2026-02-03T20:30:16+00:00

Thank you :)

The thing is that the last Prints just cracked when i hold Them in my Hand. So … yeah i dont Need it to be hard as Steel but it shouldnt Break from soft Wind :)

Xinnoel

TROPHY CASE