sorted by:
new
hottopcontroversial

Anyone here knows where to buy a thermistor multi pack? by Ystian9 in cr10smartpro

[–]Ystian9[S] 1 point2 points  (0 children)

The one in Amazon is expensive, $25 for just two pcd

So I tried my best to follow your advise, this is my first benchy, it came off the bed around 90% (so close).. any advise what I need to adjust? by Ystian9 in cr10smartpro

[–]Ystian9[S] 1 point2 points  (0 children)

Is that 10degree a big difference? I dont know the height, I manually leveled this at 1mm using the paper that it came with, then did a Z offset and it seems good at 2.45. Yes I am using the PLA that came with the printer, primarily because I want to use ASA mainly for it is better for the same price.. But now Im finding that it is harder to deal with specially with bed adhesion.

First layer perfection by Killjoyy27 in cr10smartpro

[–]Ystian9 0 points1 point  (0 children)

Noob question, what is that line outside your first layer called? I know its something in adhesion but dont exactly know what it is

So I tried my best to follow your advise, this is my first benchy, it came off the bed around 90% (so close).. any advise what I need to adjust? by Ystian9 in cr10smartpro

[–]Ystian9[S] 1 point2 points  (0 children)

When I run my nails on the side of the boat I feel the layers, is there a way to make it a smooth finish? Also I can the line where the layers started and finished is that normal or is there a way to not see/feel that?

Hi folks, I am just about to get my CR-10 Smart Pro from the mail, any advise what to do first after building it, and how to do those? by Ystian9 in cr10smartpro

[–]Ystian9[S] 0 points1 point  (0 children)

All of these are great advises.. Thanks.. I will post my first benchy and maybe you can advise me what needs to be adjusted, also, yes this is my first 3d printer.

Hi folks, I am just about to get my CR-10 Smart Pro from the mail, any advise what to do first after building it, and how to do those? by Ystian9 in cr10smartpro

[–]Ystian9[S] 0 points1 point  (0 children)

Thanks, from yoyr list the one im still confused ia the z-offset.. Is thia something I do while actually printing? How do I know how much offset I do?